Divus KNX SERVER Panduan Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Divus KNX SERVER. Divus KNX SERVER 20 halaman. Knx systems visualization solution
Halaman CetakThe LED marked with the label „POWER" on
the front of the server signals that the power
supply is active, while the "SERVICE" LED re-
mains off in normal circumstances.
KNX SERVER has furthermore the following
interfaces:
˚ SD-slot: to expand the memory of KNX
SERVER with an appropriate SD-card
˚ RS232-interface and 2 USB-ports: for integ-
ration of third party systems
The connection to the KNX bus is
not really needed for the configura-
tion of KNX SERVER, but it allows a more
efficient programming, since direct tests
of the system can be performed.
2.3.2 ENVIRONMENTAL CONDITIONS
The correct function of KNX SERVER can be granted only if the following requests are met:
OPERATION
STORAGE
2.3.3 COMMISSIONING
DIVUS KNX SERVER is power supplied by a po-
wer adapter NOT included in the KNX SERVER
packaging.
The device supports power supply voltages of
12-30V DC.
When commissioning KNX SERVER, the fol-
lowing steps must be followed:
˚ Power off the system/installation
˚ Install KNX SERVER on a DIN-Rail
˚ Connect power supply and KNX bus to
KNX SERVER
˚ Power on the system/installation
˚ Wait until KNX SERVER has booted up
ATTENTION!
If the KNX SERVER hardware is
changed, irreversible damage can occur.
Any intervention on the equipment should
be performed only by authorized person-
nel of DIVUS.
Ambient temperature 0°C - 50°C
Ambient temperature -10°C - 70°C
ATTENTION!
Before commissioning KNX SERVER
all connections must be checked! Verify that
the voltage of the connected power supply
doesn't exceed the supported voltage ran-
ge, in order to avoid damage on the device!
7