ACOUSTIC SOLUTIONS DR-120 Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pembicara ACOUSTIC SOLUTIONS DR-120. ACOUSTIC SOLUTIONS DR-120 13 halaman.

CONTROL AND OPERATION

This section describes the compact disc player's controls in the order in

which you would normally use them. Follow the instructions step-by-step

and in a very short time you will master complete operation of the unit.

If the disc is correctly loaded, the following information will be displayed.

EXAMPLE: There are 8 tracks on the disc.

The disc has a total playing time of 48 minutes and 54 seconds. The CD

player will be set to the standby mode.

NOTES:

•

After the disc tray is fully closed, "NO" may be displayed. This means

that the disc is improperly loaded (most likely upside down). To check,

open the disc tray again and reload the disc correctly.

•

If the disc tray is blocked while closing, the tray will stop and open

automatically after a few seconds. If this happens, check the disc tray.

Remove any obstacle before closing the tray again.

NORMAL DISC PLAY

Before playing a disc, check the CD player's power cord and output cable

connections (refer to the section CONNECTING THE COMPACT DISC

PLAYER).

1. Switch on the amplifier and set its input selector to the correct position

for the CD player, or plug the headphones into the headphones socket.

Adjust the headphones volume control to minimum.

2. Press the POWER switch.

3. Press the OPEN/CLOSE button to open the disc tray, and load a disc.

4. Press the OPEN/CLOSE button again to close the disc tray.

5. Press the PLAY button. Disc play will start from the beginning of the

first track. If the desired track has been selected by

before pressing the PLAY button, disc play will start with the selected

track when the PLAY button is pressed. Adjust the headphones volume

control to a desired listening level when using the headphones.

6. When the last track has finished playing, the CD player will return to

the standby mode.

NOTES:

If a disc is seriously scratched, or too dirty, disc play may not start.

If an improperly centered disc is played, noise can be heard in the

mechanism. The use of such discs should be avoided.

NORMAL OPERATION

When switching on the power, the TRACK display will show "_ _" for 5

seconds

If there is a disc, the display will show the total number of tracks and total

playing time.

If there is no disc, the display will show " no "

button