ESI Enmo 2NM-C48-WHT Manual Petunjuk Perakitan dan Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan dan Pengoperasian untuk Perabotan Dalam Ruangan ESI Enmo 2NM-C48-WHT. ESI Enmo 2NM-C48-WHT 12 halaman. Electric height adjustable table base

Halaman Cetak
ESI Enmo 2NM-C48-WHT Manual Petunjuk Perakitan dan Pengoperasian
Enmo
Step #10: initialize table and test operation
• Plug the power cord into an outlet or power strip.
• Initialize the table by pressing both the UP s and DOWN t buttons on the handset at the same time.
— Continue to press both buttons until you hear a soft beep sound.
— The table will move to its lowest position and then "bump up" slightly.
• Press the UP s and DOWN t buttons individually to test operation.
— End your test with the legs fully lowered.
— Unplug the power cord.
NOTICE: The table must be re-initialized when power is restored.
• If there are problems with operation, check that all cable and cord connections are secure.
— Re-initialize the table. Be sure to press both buttons until you hear the beep sound. Be sure the table moves to its lowest position and then "bumps up" slightly.
— If problems continue, call ESI Customer Service at 800.833.3746.
Step #11: complete the installation
• With the assistance of a helper, turn the table upright and place it in its final position.
— Important: There must be an inch of clearance on all sides of the worksurface (and other moving parts) to ensure free, unobstructed movement.
• If necessary, adjust the leveling glides on the feet to level the worksurface. Each glide can be adjusted up to ½".
• Plug the power cord into an AC outlet.
• Re-initialize the table. See Step #9 above.
NOTICE: Whenever the unit is unplugged or the power is cut, the table must be re-initialized.
Page 9
Assembly and operation
press both to
initialize table