ACOUSTIC SOLUTIONS SP110 Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Pembicara ACOUSTIC SOLUTIONS SP110. ACOUSTIC SOLUTIONS SP110 18 halaman. Hi-fi separates dab tuner

BUILDING A STATION LIST

Following the initial autotune upon power up, the SP110 will build a station list of services that

exist in your area.

The default way in which these stations will be displayed on the LCD panel is in alphanumeric

order (to change this see page 12 ), recognising numbers before letters, therefore stations such

as 6 Music from the BBC will be listed first.

To change which station you are listening to, simply turn the rotary function control knob

clockwise to scan up through the alphabetical stations list, or anticlockwise to scan down.

This changing list will be shown on line 2 of the LCD display, with line 1 showing the current

station which your are listening to. To select a new station from the scrolling list, push the

function control knob to make your selection. (Note it is only necessary to press this button once

to make your selection). The DAB station will change to your new selection.

(Note: by pressing the function control knob again, the signal strength will be shown on line 2

of the display, it will then be necessary to push this knob again to remove the signal strength

display from line 2 of the LCD).

Once the SP110 has built a station list, it will retain this list in memory unless you decide to

reset it. Sometimes it may be the case that a particular DAB station is not available in your

area, however the station still exists in the memory of the SP110. This may occur if the DAB

tuner has been moved, and is now being operated in a different location. It may also be that

secondary level DAB stations (as described on page 2 ) are not being broadcast, thus leaving

this channel inoperative.

In this situation the LCD display will show a '?' in front of the station name to indicate that

service is not available. If you decide to select this station, the display will read 'Station not

available' and will revert back to the previous service.

To clear the station list from the memory of the SP110, it is possible to operate a factory reset

function. To do this hold down the function button for a period longer than 2 seconds, the LCD

display will ask you to confirm this operation, press the rotary control knob to accept.

It is also possible to 'tidy' the station list to remove stations which are in the memory, but have

no service provided, this procedure is described on page 12 in the station order menu of the

function control.

Turn rotary control knob clockwise to

scan up through alphabetical stations

list, or anticlockwise to scan down

the list.