Akiyama DX-303 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Meja putar Akiyama DX-303. Akiyama DX-303 11 halaman.

Halaman Cetak

TONE ARM ASSEMBLY

1. Push the power to on and the speed indicator and the strobe-

illuminator will light up.

2. Insert target light for illumination the stylus.

3. Place a record on the turntable mat. When playing a 45rpm

record with a large center hole; place the 45-rpm adapter on the

centre spindle.

4. Set the rotation speed (33/45/78) to match the record.

5. Release the arm clamp.

6. Set the cueing lever to the up position.

7. Press the Start/Stop button and the turntable platter will start to

rotate.

8. Move the tone arm over the desired groove.

9. Set the cueing lever to the down position, the tone arm will descend

slowly onto the record and play begins.

19.Headshell - Install cartridge here. When installing a cartridge, refer to the

installation instructions supplied by the manufacturer of that cartridge. During

installation, attach the stylus protector to guard the stylus tip from damage.

Attach wires as follows:

White (L+)

Blue (L-)

Red (R+)

Green (R-)

20.S-Shaped Tone Arm

21.Tone Arm Lift - This elevates the tone arm above the record surface.

22.Anti-Skate Control - This applies inward force to the tone arm so it doesn't skip

outward across the record due to the centrifugal force of the record spinning.

Cartridge manufacturers usually specify the proper setting of this.

23.Counterweight - Adjustment creates the proper downward pressure of the

stylus to the record. Attach now by sliding the counterweight onto the rear of the

tone arm. Twist it lightly and it will screw onto the rear shaft of the tone arm.

1 9

24.Tone Arm Clamp and Rest - Use this rest for the tone arm and clamp it in

position during transportation.

OPERATION

dx turntables

Left channel+

Left channel -

Right channel+

Right channel-

10. Set the desired pitch adjusts range by depressing the buttons until

the desired pitch is reached.

Options are +/-8% or +/-12% or +/-20%.

11. Adjust the pitch to a desirable speed. During play, observe the

strobe dots. If the strobe dots appear to the right, the pitch is

slower than the rated speed. If they flow to the left, the rated

speed.

If the strobe dots appear stationary, which means the platter is in

normal turntable speed, move the pitch control slider up or down

to adjust the speed.

12. To suspend play, lift tone arm with cueing lever.

13. When play is finished, raise the cueing lever, move the tone arm to

the armrest and secure the tone arm with the arm clamp.

14. Press the Start/Stop button to stop the platter rotating.

15. Push the power to off.