ABC PROIZVOD CONCEPT 2 Petunjuk Teknis - Halaman 11

Jelajahi secara online atau unduh pdf Petunjuk Teknis untuk Peralatan Dapur ABC PROIZVOD CONCEPT 2. ABC PROIZVOD CONCEPT 2 16 halaman. Central heating cookers

Halaman Cetak

IIMPORTANT NOTE:

First fuel feeding may cause condensation – water drops and humidity in the ashtray. In

this case, increase the cooker temperature gradually and this phenomenon will disappear.

6.2. OPERATION

The cooker is fed with fuel as all the other continuously burning solid fuel boilers. The fire is

started with the ashtray door open. Having opened the firebox door, put the paper and small

prices of wood on the grid and start the fire. Put the heating material gradually into the firebox until

the fire intensifies. Only then fill the firebox, close the ashtray door and set the drought controller

to the desired temperature.

6.3. USE OF GRID

The cooker has water-cooled grid, made of seamless tubes as well as ash ejector, F.1 and F.2,

pos. 7, allowing efficient ash ejection from firebox into the ashtray. This enables a better fresh air

supply to combustion area. The cooker also has a feature that the firebox may be lifted with the

grid, which is placed on suitable holders.

The grid is an accessory, and if desired, the customer may either purchase it directly from the

manufacturer or order it through a distributor. This grid is intended for use in a transitional season,

when external temperature is not too low. Placing this grid, the heating effect on the hob is

enhanced, and thus food is boiled and roasted faster, and the cooker may also be used for

heating confined premises.

6.4. TEMPERATURE CONTROL

On the cooker panel, F.1 and F.2, pos. 8, a drought controller is installed, which function is to set

the desired temperature, and in consists of a numerical wheel with 0-8 scale, then of controller

flap and capillaries. A thermometer is installed on the cooker, F.1 and F.2 pos. 2, showing the

water temperature in the cooker. By means of capillaries, the draught controller (as well as the

thermometer) is connected with the probe from which it collects the details about water

temperature value in the cooker.

The cooker temperature is the lowest when the drought controller is set to no.1, and it is the

highest when the drought controller is set to no 8. When the cooker temperature starts to fall, the

controller flap is open automatically by 3-5 mm, allowing the flow of secondary drought (air) and

better combustion up to the desired temperature. the drought controller settings depend on the

desired area temperature.

IMPORTANT NOTE:

For correct functionality of the drought controller, connect the cooker to the chimney with

stipulated dimensions.