Altocraft 241-9902 Panduan Operator - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Operator untuk Bor Altocraft 241-9902. Altocraft 241-9902 9 halaman. 18v cordless drill & worklight kit
Halaman Cetak
•
Release the trigger when a clicking sound indicates the chuck will not turn further.
•
For drilling, always use the drill setting, indicated by the pictogram of a drill bit.
At this setting, the drive will not disengage from the chuck.
KEYLESS CHUCK
•
Center the rotation direction knob to prevent the motor from accidentally starting.
•
Note there are two rings on the chuck. Turn the endmost knurled ring of the
chuck clockwise by hand while, holding the second ring with the other hand
(closer to the rear of the tool) to prevent the motor from turning; this closes the
jaws of the chuck. Turning that same endmost knurled ring counter-clockwise
opens the jaws.
•
Open the jaws to accept the bit and then close the jaws so they clamp the bit
tightly.
SPORTLIGHT
To turn the light on, insert the battery pack and press the trigger switch ON.
Press it again to turn the lamp OFF.
The entire spotlight head (the black portion of the light) rotates to angle the light
from 0 to 60 degrees in a vertical plane.
To change the spotlight head angle
1.
Hold the spotlight handgrip in one hand with the lens facing away from you.
2.
Grasp the head and bezel (the black portion of the light) with the other
hand and twist it clockwise (behind) by 180 degrees.
3.
The lens will now be facing up at about 60 degrees.
If the lightbulb burns out, a spare lightbulb is included, stored inside the spot-
light head.
1.
Hold the head with the lens facing you.
2.
Unscrew the bezel/reflector/lens assembly by turning it counterclockwise.
3.
A spare lamp is located above and slightly to the left, behind the main
lamp.
4.
Remove the burned-out light bulb from the spring that holds it and replace
it with the spare.
5.
Replace the bezel/reflector/lens assembly by turning it clockwise.
BATTERY PACK and CHARGER
Battery must be fully charged for a minimum of 6 hours before using the drill.
Batteries will reach full performance after about five charge/discharge cycles.
Always have the drill rotation switch in neutral/lock position when removing or
inserting the battery to avoid unintentional starting.
To remove the battery pack from the tool, press the lock spring buttons and pull
out.
To insert, simply push the battery pack in until the lock spring clicks.
The battery charger consists of two parts:
1.
a combined transformer/120 volt plug with a low-voltage lead
2.
a charging stand
Insert the transformer/plug into a 120V household current receptacle.
The step of the battery pack has positive and negative terminal markings on it.
Align these with the identical markings on the top of the charging stand and
insert the battery pack into the base (The pack will not insert properly if reversed).
The red light is the power indicator. When the charger is connected to the AC
household current, the red light is on.
The green light is the charge indicator. When the battery is properly inserted
into the charger and charging, the green light is on.
Normal charging time is 3 to 5 hours. The charger will charge the battery at the
normal rate until the charging is complete. The current will then diminish and continue
to provide a small trickle charge. The battery temperature will then cool to normal.
When charging more than one battery pack in succession, allow 15 minutes
between the charges.
OPERATING PROCEDURES
5