Altocraft 208-1701 Panduan Operator - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pistol Kuku Altocraft 208-1701. Altocraft 208-1701 10 halaman. 18 ga.brad nailer with 12-piece starter kit

Halaman Cetak

SETUP & OPERATION

OPERATING THE TOOL

1. The depth to which a brad is driven is determined by the supplied air pressure.

CAUTION:

2. Make sure the air pressure is within the limits mentioned in SPECIFICATIONS.

3. Hold the BODY (F, fig.1) and press DRIVER GUIDE (E, fig.1) against the work

surface, being sure the tool is perpendicular to the surface.

4. Gently squeeze the TRIGGER (A, fig.1) to drive the fastener.

5. Lift the tool off the work surface.

MAINTENANCE

DAILY MAINTENANCE AND INSPECTION

CAUTION: Disconnect tool from air supply before cleaning and inspection.

Correct all problems before putting the tool back in service.

CAUTION: Such solutions may damage O-rings and other parts.

Push the MOVABLE MAGAZINE (C, fig.1) forward until the FIXED LEVER

(B, fig.1) clicks and locks it.

The tool is ready to operate.

Test ﬁre a brad into a sample of the material you will be working on and check

depth. If a change is desired, adjust the regulator to supply air at a higher or

lower pressure. Test ﬁre another fastener and check depth again. Adjust as

necessary.

Keep tool pointed in a safe direction at all times.

Never attempt to drive fasteners into materials too hard to penetrate, at too

steep an angle, or too near the edge of the workpiece. The fastener can

ricochet causing personal injury.

Disconnect tool from air supply before doing any disassembly, maintenance,

clearing a jammmed fastener, leaving the work area, moving the tool to

another location, or handing the tool to another person.

Clean and inspect the tool daily. Carefully check for proper operation of

trigger and safety mechanism. Do not use the tool unless both the trigger and

the safety mechanism are functional, or if the tool is leaking air or needs any

other repair.

Wipe tool clean and inspect for wear or damage. Use non-ﬂammable cleaning

solutions to wipe exterior of tool only if necessary. Do not soak tool with

cleaning solutions. Such solutions can damage internal parts.

Inspect trigger and safety mechanism to assure system is complete and

functional: no loose or missing parts, no binding or sticking parts.

Keep all screws tight. Loose screws can cause personal injury or damage the

tool.

If the tool is used without an in-line oiler, place 2 drops of air tool oil in the

air inlet of the tool at the beginning of each workday and after about 1 hour

of continuous use. Frequent but not excessive lubrication is required for best

performance. Oil added through the airline connection will lubricate all internal

parts. Use only air tool oil. Do not use oil with detergents or other additives.

These can cause damage through accelerated wear to the seals in the tool.

Use a small amount of oil on all exterior moving parts and pivots.

Dirt and water in the air supply are major causes of pneumatic tool wear. See

the section on SETUP & OPERATION: AIR SYSTEM for more information.

Keep tools clean for better and safer performance. Use non-ﬂammable

cleaning solutions sparingly and only if necessary. Do not soak parts in the

solutions.