Alton ECOMAX ELG04 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Blower Alton ECOMAX ELG04. Alton ECOMAX ELG04 9 halaman. 18v cordless leaf blower

WARNING! If the battery pack or charger is damaged, replace the battery pack or the

charger.

WARNING! Stop the machine and wait until the motor stops before you install or remove

the battery pack

WARNING! Read and understand the instructions in the battery and charger manual.

3. REMOVE THE BATTERY PACK

1） . Push and hold the battery release button.

2） . Remove the battery pack from the machine.

4. START THE MACHINE

Press the switch to trigger 4.

5. STOP THE MACHINE

Release the trigger(component 4) to stop the machine.

6. OPERATION TIPS

Release the trigger(component 4) to stop the machine.

Blow around the outer edge of the unwanted materials to prevent the unwanted materials from

scattering. Use rakes and brooms to clear the unwanted material before you blow.

Make the surfaces wet before you clear the unwanted material in dusty conditions.

Look out for children, pets, open windows, and cleaned cars during operation.

Clean the machine.

Discard the unwanted material when you complete work.

7. MAINTENANCE

CAUTION! Do not let brake ﬂuids, gasoline, petroleum-based materials touch the plastic

parts. Chemicals can cause damage to the plastic, and make the plastic unserviceable.

CAUTION! Do not use strong solvents or detergents on the plastic housing or compo-

nents.

WARNING! Remove the battery pack from the machine before maintenance.

8. CLEAN THE MACHINE

CAUTION! The machine must be dry Humidity can cause risks of electrical shocks.

Clear the unwanted material out of the air vent with a vacuum cleaner.

Do not spray the air vent or put the air vent in solvents.

Clean the housing and the plastic components with a moist and soft cloth

9. OVERLOAD PROTECTION

When overloaded, the motor comes to a stop Relieve the load on the machine immediately and

allow cooling for approx 30 seconds.

10. TEMPERATURE DEPENDENT OVERLOAD PROTECTION

When using as intended the power tool cannot be subject to overload. When the load is too high

or the allowable battery temperature of 75° C is exceeded the electronic control switches oﬀ the

power tool until the temperature is in the optimum temperature range again.

11. PROTECTION AGAINST DEEP DISCHARGING

The Li-ion battery is protected against deep discharging by the"Discharging Protection System.

When the battery is empty, the machine is switched oﬀ by means of a protective circuit: The

inserted tool no longer start.