Dixon Bayco Petunjuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Peralatan Industri Dixon Bayco. Dixon Bayco 5 halaman. Locking handle kit
Juga untuk Dixon Bayco: Petunjuk Pemeliharaan & Pengoperasian (4 halaman), Petunjuk Pemeliharaan & Pengoperasian (4 halaman), Petunjuk Pemeliharaan & Pengoperasian (10 halaman)

FloTech Thermo-Optic Sensors and Thermistor Dummy

Retain Sensor

FloTech model FT152 is designed to fit into a ½ NPT half coupling

welded into the bottom of each compartment. The mounting location

should be the lowest point of the tank. The collar should not protrude

more than ¾ inch outside the tank and flush with the inside of the

tank when possible. FloTech supplies a ½ NPT weld coupling with

each sensor. The coupling requires a 1 1/8" diameter hole cut in the

bottom of the tank. After the welded coupling has cooled, install the

sensor using pipe sealant or Teflon tape to lubricate and seal the

threads. Check thread engagement to ensure the retain sensor

prism tip is set deep enough into the tank as to clear weld collar.

DO NOT USE THE BODY OF THE SENSOR TO TIGHTEN!

Dixon Bayco Warranty

For complete warranty information, please refer to the latest

Dixon catalog.

THERMO-OPTIC SENSORS

Rev: Dec 2008