Bambi PT15 Panduan Buku Pegangan Operator - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Buku Pegangan Operator untuk Rentang Bambi PT15. Bambi PT15 12 halaman. Pt models
Juga untuk Bambi PT15: Panduan Buku Pegangan Operator (12 halaman), Panduan Buku Pegangan Operator (12 halaman)

Operation

Starting & Stopping

Plug the compressor into an outlet socket of nominal voltage.

Switch the compressor on by turning the red control

on top of the pressure switch to the "Auto" position.

The compressor will run until the pressure in the receiver

is at 8 bar. It will then cut out.

As air is used the pressure drops and the motor will restart at the preset pressure.

There is approximately a 2 Bar differential.

Note!

Each time the compressor switches off, you will hear a short hiss of air. You are

hearing the unloader valve discharging the residual delivery pipe pressure.

This is normal.

Adjusting Outlet Pressure

Use the pressure regulator to adjust the outlet pressure.

To increase line pressure, rotate the knob in a clockwise

direction; to decrease turn anti clockwise.

It is possible to lock the setting by

pushing the knob down until it "clicks" home.

There are two pressure gauges on each model.

The larger gauge indicates the air receiver pressure, the smaller gauge indicates the

air outlet pressure.

NOTE!

NEVER unplug the compressor when running. Always switch off using the red

control on the pressure switch to ensure the compressor discharges.

Failure to do so will cause damage and will invalidate your warranty.