ClearSpan PB00566R3 Buku Petunjuk - Halaman 10
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Tenda ClearSpan PB00566R3. ClearSpan PB00566R3 18 halaman. Freestanding “hut” style model 14' wide x 14' high x 36' long
Halaman CetakSection C - Rafter Setup
Step 1: Stand up one of your end rafters (one of those with the band clamps attached). Secure it to
an existing structure if possible so that it is plumb. If you donʼt have an existing structure, you
can use some 2x4s as shown tied with rope:
Step 2: Insert purlins into the clamps at the bottoms of the end rafter and tighten the clamps.
The ends of the purlins should extend a half inch or less past the clamp, or the rough end of
the purlin could damage the cover when it is installed later. Note that the bolt side of the end
clamps must go toward the "inside" of the shelter" (the same side as the purlin) as shown.
Step 3: Slide an inside rafter (without band clamps) onto the two purlins. Position this 2nd rafter
from the end rafter using a rafter-to-rafter distance of 36" for R3 models and 48" for R4 models.
Have your partner hold the rafter in position while you tighten the purlin clamps at the ends of
this rafter.
Step 4: Slide a purlin through the clamp at the top of this rafter and also the clamp at the top of the
end rafter. Tighten the bolts with the end of the purlin a half inch past the clamp.
Page 10