ClearSpan PB02000R4N Petunjuk Manual - Halaman 8
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Tenda ClearSpan PB02000R4N. ClearSpan PB02000R4N 13 halaman. Round style mini garage
Halaman CetakASSEMBLE END CONDUITS
Gather the Parts
•
Pipe 1.315"x49.5" Plain 17 GA (2) (#131P0495)
•
Pipe 1.315"x75" Swaged 17 GA (2) (#131S075)
•
Short Tee 1" (4) (#10015106)
•
Duct tape
•
Tek Screws (#FA4482B)
Assembly Procedure
1. Locate end conduit pipes and short tees.
2. Assemble both sets of end conduit sections by
connecting the 75" swaged pipe to the 49.5" plain
pipes, secure the joint using a Tek screw, and tape
over the Tek screw to protect the end panel.
3. Add the short tees at the ends.
NOTE: Do not insert the end conduit pipes all the way
into the short tees, but instead allow for room for the
vertical pipe to be inserted later on.
PREPARE END PANELS
! CAUTION: To prevent damage, do not install end
panels on a windy day.
Gather the Parts
•
End Panel 10x8 12.5oz Green Solid (Plain)
(#QE02000NZO)
•
End Panel 10x8 12.5 oz. Green 2-Zip (Zippered)
(#QE02000NZ2)
•
End Conduit Assemblies (2)
•
Scissors
Assembly Procedure
1. If the corners of your end panels have not been cut
out, follow this procedure:
a. Lay an end panel out on a clean flat surface.
b. Place the end conduit assembly centered side-
to-side on top of the hem as shown in Figure 11.
c. With scissors, trim the corner of the end panel
on the dotted line shown in Figure 11 so the
short tee is exposed when it is placed inside the
hem.
Visit www.ClearSpan.com for additional products and customer assistance.
d. Repeat Steps A-C at the other end of this
end panel and on both ends of the remaining
end panel.
Figure 11. Trimming End Panel
2. Remove one short tee from the end conduit
assembly and slide the end conduit assembly into
the hem at the bottom of the solid (plain) end panel
as shown in Figure 11. Replace the short tee you
removed.
3. On the zippered end panel, insert the end conduit
only through the two side panels of the end panel
and not through the middle door section as shown in
Figure 12.
End conduit
through
side panel
Figure 12. Zippered End Panel
Middle Door
End conduit
through
side panel
7 of 12