ClearSpan R030A00008 Manual - Halaman 6
Jelajahi secara online atau unduh pdf Manual untuk Tenda ClearSpan R030A00008. ClearSpan R030A00008 13 halaman. Twin-wall polycarbonate end panel kit 30' wide & 35' wide
Halaman CetakEND PANEL INSTALLATION (continued)
4.
Locate and mark the center of the end wall and set
the first prepared panel, with the UV-protected side
facing to the outside, in position.
ATTENTION: Consult the diagram in the Quick Start
section for your end wall. The 35' wide end wall
begins with a 6' x 8' panel centered in the end wall.
(See lower diagram to the right.) The 30' wide end
wall is shown below.
5.
Verify that the panel is square on the frame and in the
desired position and attach it to the end frame using
Tek screws and washers (see photo to the right).
Install the Tek screws through the panel and into the
girt every 12" on-center. Do not overtighten screws!
NOTE: Do not use washers on Tek screws when
securing the H-channel to the girt. Install Tek screws
in the channel of the aluminum H-channel.
6.
With the first panel attached to the end frame, verify
that the UV-protected surface is toward the outside,
and repeat the steps to install the next panel.
Diagram below shows the 30' wide end wall. Actual end
frame and panels may differ from frame shown. The
installation of doors also will affect panel installation
and position. Consult the panel diagrams located in the
Quick Start section for the end kit ordered.
30' Wide End Wall
Ground Level
6
End Panel Installation
Center of end frame
4' x 8'
Panel
A
Tek screws
and washers
Use assistants when setting and securing the
panels to the end frame.
6' x 8'
Panel
6' x 8'
Panel
35' Wide End Wall
4' x 8'
A
Panel
Girt
Girt
Tek screw
only
Revision date: 06.02.09