ClearSpan R030B00007 Manual - Halaman 3
Jelajahi secara online atau unduh pdf Manual untuk Tenda ClearSpan R030B00007. ClearSpan R030B00007 11 halaman. Corrugated polycarbonate end panel kit 30' wide & 35' wide
Halaman CetakYOU MUST READ THIS DOCUMENT BEFORE YOU
BEGIN TO ASSEMBLE THE END PANEL KIT.
Thank you for purchasing this ClearSpan™ Corrugated
Polycarbonate Kit. When properly assembled and
maintained, this product will provide years of reliable
service. These instructions include helpful hints and
important information needed to safely assemble
and properly maintain the panels. Please read these
instructions before you begin.
SAFETY PRECAUTIONS
•
Wear eye protection.
•
Wear head protection.
•
Use a portable GFCI (Ground Fault Circuit
Interrupter) when working with power tools and cords.
•
Do not climb on the shelter or framing during or after
construction.
•
Do not occupy the shelter during high winds,
tornadoes, or hurricanes.
•
Provide adequate ventilation if the structure is
enclosed.
•
Do not store hazardous materials in the shelter.
•
Provide proper ingress and egress to prevent
entrapment.
WARNING: The individuals assembling this end
panel kit are responsible for designing and furnishing
all temporary bracing, shoring and support needed
during the assembly process.
For safety reasons, those who are not familiar with
recognized construction methods and techniques
must seek the help of a qualified contractor.
NOTE: Many ClearSpan™ shelters and greenhouses can
be designed to meet the snow and wind load requirements
in your area. Contact your account manager for additional
information if needed.
Revision date: 06.04.10
Important Information
REQUIRED TOOLS
The following list identifies the main tools needed to
assemble the end panel kit. Additional tools and supports
may be needed depending on the structure, location, and
application.
•
Tape measure or measuring device
•
Fine point marker to mark the location on panels.
•
Variable speed drill and impact driver (cordless with
extra batteries works best)
•
Scissors or utility knife and tool to cut the
polycarbonate panels
•
Hammers, gloves and eye protection
•
Ladders, work platforms, and other machinery for
lifting designed to work safely at the height of the
building and end wall.
ATTENTION: Consult the services of a qualified,
professional contractor if you are not familiar with the
construction of similar frame structures.
SEALANT APPLICATION (OPTIONAL)
The application of sealant is left to the discretion of the
owner/contractor. If used during panel installation, apply
a sealant recommended for exterior use and that remains
flexible when cured. To create a better seal, apply sealant
between adjacent panels where the panels overlap each
another. Sealant is not included with the building and must
be supplied by the customer.
Rib Overlap
Sealant
Contact your sales representative to purchase sealant to
seal the end panels during installation.
ATTACHING THE PANELS
When setting the panels in position, remember to install
each panel with the UV-protected surface facing toward
the outside. Read the information printed on each panel.
The diagrams in the Quick Start section show frames
with installed sidewall panels. View these before
attaching the panels to determine the best way to align
the end panels with the sidewall panels if your building
is equipped with sidewall panels.
Corrugated Panel
3