ClearSpan 104903 Manual Petunjuk Perakitan - Halaman 10

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Kit Rumah Kaca ClearSpan 104903. ClearSpan 104903 19 halaman. Premium solar star greenhouse

Halaman Cetak

NOTE: The distances indicated by arrows in the

previous diagrams are the same when the frame is

square. During the roof panel installation, periodically

check the frame for square. The frame must remain

square for the panels to install correctly.

26. After squaring the frame, locate a short section of

roof support plate (26") and attach the support to the

inside top of the first small side panel.

Roof Support

Plate

NOTE: The first roof support plate is installed with one

end positioned past the edge of the short side panel and

flush with the polycarbonate of the door or non-door

angled panel. See the photo that follows.

Roof Support Plate

27. Choose four (4) forty-eight inch (48") roof support

plates and attach them to the tops of the short side

panels and work toward the other end of the

greenhouse.

28. Complete the installation of the lower roof support

plates by installing another 26" section.

Visit www.ClearSpan.com for additional products and customer assistance.

Angled End

Panel

Inside View

NOTE: To strengthen the side panel seams, the roof

support plates are designed so that they join near the

center of the smaller side panels.

26"

NOTE: In the above diagram, the smaller side panel (X)

has been moved to better show the roof support plates

and their locations.

29. After installing the lower roof support plates, move to

the remaining side of the greenhouse and install the

upper roof support plates.

The upper roof support plates are attached in the same

manner and pattern as previously described. See the

photo that follows.

Upper Roof Support Plate

30. After installing the roof support plates, attach four (4)

3" x 3" square flat brackets to the underside surface

of the end panel frame tubes in the locations shown

in the diagrams on the next page.

Repeat for the door end panels.

9 of 18