ClearSpan R030B00000F Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Tempat penampungan ClearSpan R030B00000F. ClearSpan R030B00000F 5 halaman. 30' wide rafter kit with mounting feet

Halaman Cetak

Side Profile Connection Details

When additional rafters are added to a standard building to change the rafter spacing from 6' on-center to 4' on-center,

cable patterns may change for some building lengths. The Side Profile diagrams in this guide show the cable patterns

for buildings with 4' on-center rafter spacing. Use the diagrams for your building during the assembly.

REMEMBER: A standard building has 6' on-center rafter spacing. The diagrams in this guide show frames with 4' on-

center rafter spacing. This 110644 kit is not used when additional rafters are purchased to lengthen the original building.

The diagrams on this page correspond to the details circled on the main Side Profile diagrams found on the remaining

pages. Some details may not apply to some frame lengths. In some instances, the cable bracket shown in Detail A and

Detail B is used to secure two (2) cables or four (4) cables. To secure two (2) cables, use two of the connection points on

the 108874 bracket only. Actual angle of the cable runs may vary from the detail. Consult the Side Profile diagrams.

Use the components contained in the 110644 adaptor kit sent with your building. This kit is used for all building widths

and lengths. Some components may not be needed for your building. Consult the diagrams in this guide to determine

what components of the kit are needed for your building when rafter spacing is 4' on-center.

Adaptor Kit #110644 contains these parts:

108874

Double Roll Form Cable Connection Plate

108868

FAME08B

FALB04B

FAMA38B

108503

108871

DETAIL A

DETAIL C

EYE BOLT (108868)

LOCK WASHER (FAMA38B)

3/8" HEX NUT (FALB04B)

CABLE ASSEMBLY

Revision date: 11.02.10

3/8" Cable Eye Bolt (welded shut)

3/8" flat washer (zinc)

3/8"-16 nut (zinc)

3/8" lock washer (zinc)

1/8" steel cable bracket (135 degree)

7' Strut 1.66 14g single punch (82")

108874

RAFTER

AS2167

(SHACKLE)

DETAIL B

108874

DETAIL D

AS2167

(SHACKLE)

ATTENTION: REPLACE

THE ORIGINAL STRUT

108872 WITH THE

SHORTER 108871

STRUT INCLUDED IN

THIS ADAPTOR KIT.

FAME08B

(3/8" FLAT WASHER)

108503

(CABLE BRACKET)

CABLE ASSEMBLY