Altrad FEND-H05-MCH Petunjuk Asli, Petunjuk Keselamatan, Suku Cadang - Halaman 14

Jelajahi secara online atau unduh pdf Petunjuk Asli, Petunjuk Keselamatan, Suku Cadang untuk Pembagi log Altrad FEND-H05-MCH. Altrad FEND-H05-MCH 20 halaman.

Halaman Cetak

lower marking

7. Check the oil seal and replace it if it is damaged in any way.

oil seal

8. Replace the dipstick and screw it firmly into place.

Caution! Do not tighten the screw too tightly, since this may

damage the oil seal or the thread in the cylinder cover.

Fig. 10

Dipstick

When should I change the oil?

The first oil change should be carried out after 50 operating

hours, and then every 250 operating hours.

Changing the oil:

1. The log ram must be in its starting position.

2. Place a container under the log splitter to catch the old oil.

The container should have a capacity of at least 4 litres.

3. Unscrew the dipstick. Do not drop or lose the oil seal when

removing the dipstick.

4. Now tip the machine to empty the oil into the container.

5. Stand the log splitter on end, with the filler opening at the top.

Fig 10.

A second person will be required to up-end and hold

the log splitter.

6. Pour in the new hydraulic oil (2.5 or 3.0 litres) using a clean

funnel.

7. Clean the dipstick and the oil seal.

8. Check the oil seal and replace it if it is damaged in any way.

9. Replace the dipstick and screw it firmly into place.

Caution! Do not tighten the screw too tightly, since this may

damage the oil seal or the thread in the cylinder cover.

Dispose of the old oil properly (local oil disposal point). The

old oil must not be poured into the ground or drainage

system, or mixed with other waste.

upper marking

Hydraulic oil

We recommend the following hydraulic oils for the hydraulic

cylinder:

Shell Tellus T 22

Aral Vitam Gf 22

BP Energol HLP 22

order no. 400142 (1 litre)

Mobil DTE 11

or equivalent

Do not use any other types of oil. The use of any other type

of oil will adversely affect the operation of the log splitter.

Please refer to the drawing for spare parts.

Ordering spare parts:

available from the manufacturer

orders must quote the following information:

• spare parts no.

• quantity required

• model

• name of the model

Example: K3301850, 1, Fendeur de bois, FEND-H05-MCH