DIY Retractable Awnings SunCover 5000 Panduan Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori DIY Retractable Awnings SunCover 5000. DIY Retractable Awnings SunCover 5000 11 halaman.

Halaman Cetak

PITCH ADJUSTMENT

SunCover 4000 Model:

To adjust the pitch on the, start by extending your awning to its "out" limit. Please note

that the unit is fully extended BEFORE the arms lock out and the fabric begins to sag.

When the unit is fully extended properly you will notice a ¼" or so gap between the two

arm castings at the arm elbows (where the arm cables are located).

Partially loosen the two 17mm locking bolts on the side of the shoulder assembly – DO

NOT REMOVE THE NUTS. Using a 4mm allen key, turn the 4mm setting screw located

in front of the arm shoulder (clockwise to raise the pitch and counter clockwise to lower

the pitch). Arm pitch settings should be performed by taking weight off the shoulder by

lifting upwards on the front valance bar. When the desired height is achieved, repeat the

process on the other shoulder. Once the desired pitch is achieved and the front valance

bar is level, tighten the two 17mm locking bolts on each shoulder assembly.

SunCover 5000 Model:

To adjust the pitch on this model, start by extending your awning to its "out" limit.

Please note that the unit is fully extended BEFORE the arms lock out and the fabric

begin to sag. When the unit is properly fully extended you will notice a ¼" or so gap

between the two arm castings at the arm elbows (where the arm cables are located).

Remove the plastic cap on the side of the shoulder assembly. Partially loosen the

22mm locking bolt on the side of the shoulder assembly – DO NOT REMOVE THE

BOLT. With a 10mm allen key, turn the 10mm setting screw located in the front of

the shoulder (clockwise to raise the pitch and counter clockwise to lower the pitch).

Arm pitch settings should be performed by taking the weight off the shoulder by

lifting upward on the front valance bar. When the desired height is achieved, repeat

the process on the other shoulder. Once the desired pitch is achieved and the front

valance bar is level, fully tighten the 22mm locking bolt on each shoulder and

reinstall the decorative cap.

CARE & MAINTENANCE

Fabric Care & Cleaning:

The fabric of your awning is made from 100% solution-dyed acrylic. Solution dying is the process of adding color to the

acrylic while in a liquid state before spinning the yarn. By following a few simple steps, the fabric will maintain its look and

performance for years to come. Because the fabric is woven, it is also highly breathable, which is why it dries quickly. It has

also been treated with a special finish which enhances water repellency. Also, the fabric will not support the growth of mildew;

however, dirt on the fabric can lead to mildew growth, which makes regular cleanings necessary. Your local environment has

a great deal to do with determining cleaning frequency. A dry environment requires less cleaning than a humid one.

Important Reminders:

• Always use a natural soap, never detergent • Water should be cold to lukewarm • Air dry only, never apply heat

Cleaning Steps:

1. Brush off loose dirt and debris

2. Hose fabric down

3. Mix 1/2 cup of natural soap and water

For stubborn stains, substitute a 1/4 cup chlorine bleach and 1/4 cup of natural soap for Step 3. Apply and let soak for no

more than 20 minutes then rinse thoroughly.

Frame Cleaning & Lubrication:

The frame is composed of powder coated aluminum components with stainless steel fasteners, which is virtually maintenance

free. All the hardware is made of high quality, corrosion-resistant materials. Over time, dust and dirt will collect on the frame

and will require periodic cleaning to maintain its appearance. A mild spray cleaner or water/detergent mixture may be applied

to the frame and then wiped clean. In most situations it should not be necessary to lubricate the moving component parts of

your awning.

4. Use a soft bristle brush to clean

5. Allow soap to soak in

SIDE VIEW

SunCover 4000 Model

Arm Shoulder

SIDE VIEW

SunCover 5000 Model Arm Shoulder

6. Rinse thoroughly

7. Air dry