Altrad Belle RPC 45 Panduan Operator - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pembuangan Sampah Altrad Belle RPC 45. Altrad Belle RPC 45 13 halaman.

Halaman Cetak

Assembly of the Control Pump

1. Carefully clean the housing with compressed air on the inside. Check for scratches on sliding bores for O Rings and there are

no sharp edges.

2. Press the Bushing in to Housing.

3. Lubricate the Lip Seal with Hydraulic Oil and slip it on the Rack (open side away from the rack).

4. Lubricate the Rack with Hydraulic Oil and slide it into the Housing until the Lip Seal is in the groove, making sure the teeth are

in the right position. When the Lip Seal is in the Groove this represents forward motion.

CAUTION

5. After lubricating the Pinion (without O Rings), insert it into the Housing and Rack. Check the movement of the Rack from Forward

to Reverse. (See CAUTION).

6 Take the Pinion out and t the two O Rings, making sure they are not damaged.

7. Lubricate the Pinion and O Rings with hydraulic oil and carefully insert in to the Housing. Make sure the Rack is in the right

position and this is easiest when in reverse motion.

8. Fit the Shim and Retaining Ring. It may be necessary to push the Pinion from the opposite side to get them assembled.

9. Place the Housing on the ller side and t the O Rings to the bottom face. LOCTITE seal 518 is recommended.

10. Assemble the Hydraulic Connector and Dowty Washer using LOCTITE 243.

11. Assemble the Bracket and x with 4 screws and washers using LOCTITE 243.

12. Loosely t the Plug Screw and Washer DO NOT TIGHTEN.

Your new Altrad Belle 'RPC' plate compactor is warranted to the original purchaser for a period of one-year (12 months) from the origi-

nal date of purchase.

The Altrad Belle warranty is against defects in design, materials and workmanship.

The following are not covered under the Altrad Belle warranty:

1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,

operation or user maintenance instructions.

2. Alterations, additions or repairs carried out by persons other than Altrad Belle or their recognised agents.

3. Transportation or shipment costs to and from Altrad Belle or their recognised agents, for repair or assessment against a

warranty claim, on any machine.

4. Materials and/or labour costs to renew, repair or replace components due to fair wear and tear.

The following components are not covered by warranty.

• Drivebelt/s

• Engine Air Filter

• Engine Spark Plug

Altrad Belle and/or their recognised agents, directors, employees or insurers will not be held liable for consequential or other damages,

losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.

Warranty Claims

All warranty claims should rstly be directed to Altrad Belle or Altrad Belle Inc., either by telephone, by Fax, by E-mail, or in writing.

For Warranty claims:

Altrad Belle Warranty Department,

Sheen, Nr. Buxton

Derbyshire

SK17 0EU

England

Tel: +44 (0)1298 84606

Fax: +44 (0)1298 84722

Email : [email protected]

Service & Maintenance

In reverse motion the Control Handles run parallel with the Housing in the direction of the operator.