ClearWater Lights Erica Panduan Instalasi - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Sepeda Motor ClearWater Lights Erica. ClearWater Lights Erica 8 halaman. Kawasaki concours 1400 led light kit dimmable patent pending
Juga untuk ClearWater Lights Erica: Panduan Instalasi (16 halaman), Panduan Instalasi (12 halaman)
Halaman Cetak
Step 4: Mounting The Switch and Dimmer
Mounting The Switch
• Any location can be used for the
switch, be careful not to interfere
with movement of front forks. Refer
to the steps below if you need
assistance.
• On left side of dash there is a round
plastic blanking cover.
• Drill 9/32" hole in center of
blanking cover.
• Insert the flush mount switch
Mounting The Dimmer (Handlebar)
• If possible, the dimmer should
be mounted at an existing fastener
point on the left side of the
handlebar cluster.
If a flush-mounted dimmer was
requested/included in your kit,
mount it next to your switch that
was panel mounted.
Step 5: Wiring
Wire Routing:
• Be sure to route wires so that they cannot become tangled or caught
in either a suspension part or steering part. Check movement of both
steering and suspension before riding the bike.
• It is sometimes helpful to follow existing wire routing.
Electrical:
• Run the red and black power wires directly to the battery. The fuse will
protect the system in the event of a short.
• Locate the power relay box in a safe location. Secure with a zip tie. It is
a good idea to face the relay box with the wires coming out the bottom.
This helps keep everything dry.
(Continued on the next page)
Page 5