ClearWater Lights Glenda Panduan Instalasi - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Sepeda Motor ClearWater Lights Glenda. ClearWater Lights Glenda 12 halaman. Led light kit for bmw k1600gt
Juga untuk ClearWater Lights Glenda: Panduan Instalasi (12 halaman), Panduan Instalasi (12 halaman), Panduan Instalasi (12 halaman), Panduan Instalasi (16 halaman)
Halaman CetakStep 4: Wiring
Wire Routing:
• Be sure to route wires so that they cannot become tangled or caught
in either a suspension part or steering part. Check movement of both
steering and suspension before riding the bike.
• It is sometimes helpful to follow existing wire routing.
Wiring:
• Main power needs to be connected to a switched hot. This means one
that turns off with the key. An Auxiliary hot can be used as an alternative.
Using the supplied Posi-twist connectors, connect the wires according
to the accompanying color wire diagram. Attach ground lug to ground
on frame tab or other suitable location. Be sure not use a Low beam
headlight wire on H4 headlight bikes or else the lights will shut off when
the high beam is activated.
• Find a good solid ground point for the black wire terminal ring.
• Use a Posi-twist to connect the green wire from the volume control knob
to the two green wires from the lights (3 wires).
• Use a Posi-twist to connect red wire from the fuse holder to the red
wires from lights and volume control knob (4 wires)
• Connect ground/black wire to black wires from lights and volume control
knob. (4 wires)
• If you would like to use the high beam feature (recommended), use a
Posi-tap to connect the white wire from the volume control knob to the
High Beam headlight hot lead (+). This will be on only when the high
beam is illuminated.
Page 8
Page 9