3HS RMS-V II Buku Panduan Instalasi - Halaman 3
Jelajahi secara online atau unduh pdf Buku Panduan Instalasi untuk Alarm Asap 3HS RMS-V II. 3HS RMS-V II 13 halaman. Ceiling mounted visual smoke detector
Halaman CetakInstallationshandbuch RMS-D II und RMS-V II
Operational Description
The smoke detector has 3 operating modes:
Measuring Operation
This is shown by a blinking green light on the operation di splay
Detecting Smoke
The smoke is measured by a sender and a receiver in the IR-light area. The sender sends a
pulsed directed IR-light at a set angle to the scattered light area. This forms a defined measuring
zone below the detector, which disperses light to the smoke particles in the case of a fire. The
light goes to the receiver and the receiver sends a signal to the detector electronics. The
electronics analyses the signal and an alarm goes off if the set limit is exceeded.
Empfänger
Recognizing Manipulation
Advanced measuring instruments allow for a distinction between smoke and other types of
interference that occur within the measuring area. This way solid objects will be detected as
manipulation and the smoke detector sends an alarm signal after a set amount of time. The signal
must be reset, so that the smoke detector will work again.
Recognizing Impurities
Additional sensors are used to detect the amount of impurities on the surface of the smoke
detector. When the amount of surface impurities reaches the point that it cannot detect smoke
anymore, an alarm signal will be set off after a certain amount of time. The signal must be reset,
so that the smoke detector will work again. An early exposure of the smoke detector will also be
recognized.
Installationshandbuch: RMS-D II und RMS-V II Relais
®3HStrading GmbH&Co.KG, Königsheimer Strasse 13,
D-78603 Renquishausen, Tel. 07429 33 61 Fax. 07429 91 61 335,
Sender
Rauchmelderoberfläche
Messbereich
www.3HS.de
Seite 3 von 13
Stand: 01.12.2015
Version:2.7