ClearWater Lights Glenda Panduan Instalasi - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Peralatan Pencahayaan ClearWater Lights Glenda. ClearWater Lights Glenda 12 halaman. Led light kit for bmw k1600gt
Juga untuk ClearWater Lights Glenda: Panduan Instalasi (12 halaman), Panduan Instalasi (12 halaman), Panduan Instalasi (12 halaman), Panduan Instalasi (16 halaman)
Halaman CetakStep 4: Wiring
Wire Routing:
• Be sure to route wires so that they cannot become tangled or caught
in either a suspension part or steering part. Check movement of both
steering and suspension before riding the bike.
• It is sometimes helpful to follow existing wire routing.
Electrical Connections:
(A) Main power needs to be connected to a switched hot. In most bikes,
you can use the low beam wire. (yellow / pink stripe wire shown below)
• Find a good solid ground point for the black wire terminal ring.
• Use a Posi-twist to connect the green wire from the volume control
knob to the two green wires from the lights (3 wires).
• Use a Posi-twist to connect red wire from the fuse holder to the red
wires from lights and volume control knob (4 wires)
• Use a Posi-Twist to connect ground/black wire to black wires from
lights and volume control knob. (4 wires)
(B) If you would like to use the high beam feature (recommended), use a
Posi-tap to connect the white wire from the volume control knob to the
high beam headlight hot lead (Dark Green wire, shown bottom left). This
will be on only when the high beam is illuminated.
(B) Posi-tap White
to Dark Green
High Beam Feature
Page 8
(A) Yellow / Pink Stripe
Cross Country Hot Wires:
Low Beam = Yellow / Pink stripe
High Beam = Dark Green
(B) Dark Green