Edic Saturn 17LS3-BK-SV Panduan Pemilik/Operator - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pemilik/Operator untuk Mesin Lantai Edic Saturn 17LS3-BK-SV. Edic Saturn 17LS3-BK-SV 13 halaman. Low speed and dual speed floor machine

UNPACKING YOUR NEW SATURN:
When your package is delivered, check each of the 3
cartons carefully for signs of rough handling. If the
SATURN is damaged, notify the carrier immediately
and request an inspection. Be sure to keep the cartons,
packing inserts, packing lists and carrier's receipt until
the inspector has verified your claim.
EDIC's liability ceases when the carrier picks up the
shipment. However, our customer service staff will be
happy to furnish any information needed in connection
with the claim and will attempt to expedite a resolution.
PLEASE READ BEFORE
OPERATING YOUR NEW SATURN:
Read the manual carefully and completely before at-
tempting to operate the unit. This manual has important
information for the use and safe operation of the ma-
chine. Keep this manual handy at all times.
This equipment has been engineered and manufactured
to provide excellent performance and service. To ensure
that your equipment will continue to perform as intend-
ed:
Maintain and inspect equipment regularly
Use only original EDIC parts when servicing.
Operate equipment with care.
If additional information is needed, please contact EDIC
at: 800-338-3342 or email [email protected]
All information and specifications printed in the manual
are current at the time of printing; however, because of
EDIC's policy of continual product improvement, we
reserve the right to make changes at any time without
notice.
FAILURE TO COMPLY WITH THE FOL-
LOWING WARNINGS AND INSTRUC-
TIONS WILL VOID THE WARRANTY.
WARNING!
Do not operate the machine unless trained and au-
thorized.
Do not leave the machine unattended when plugged
in. Unplug from the outlet when not in use, before
servicing, and when changing the brushes or pads.
Use indoors only.
Do not allow to be used as a toy. Close attention is
necessary when used by or near children.
Do not bypass or defeat the safety "lock-out lever. "
The machine was designed for use as per instruc-
tions and recommendations written in this manual.
Any deviation from its proper use or purpose and
the consequential damage that may occur is the sole
responsibility of the end user.
Do not use with damaged cord or plug. If the ma-
chine is not working as it should, or it has been
dropped, damaged, left outdoors or dropped into
water, take it to an authorized service center.
Do not pull or carry by cord, use cord as handle,
close a door on the cord or pull cord around sharp
edges or corners. Do not run machine over cord.
Keep cord away from heated surfaces.
Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
Do not handle plug or appliance with wet hands.
Make sure the machine is plugged into an electrical
outlet with the same voltage and frequency rating
as shown on the nameplate of the machine. Do not
attempt to plug a 115- volt machine into a 230- volt
outlet.
Do not immerse or use this machine in standing
water. Such use can cause electric shock.
Keep the electrical supply cord from contacting the
rotating brush or drive block.
Do not expose machine to freezing temperatures.
To avoid electric shock, do not expose the unit to
rain. Store indoors only.
Connect to a properly grounded outlet only. See
"Grounding Instructions. "
Turn off all controls before unplugging.
When using an extension cord, use a 3 conductor-
grounding cord, 12 gauge wire or heavier. Do not use
more than 25' of extension cord.
Do not put any object into openings.
Do not use with any opening blocked. Keep free of
dust, lint, hair and anything that may reduce air flow.
Do not operate machine in flammable or explosive
areas.
All servicing of EDIC equipment should be per-
2