Edic ENDEAVOR Panduan Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Cepat untuk Pembersih Perhiasan Ultrasonik Edic ENDEAVOR. Edic ENDEAVOR 15 halaman. Multi-purpose extractor
Juga untuk Edic ENDEAVOR: Panduan Pemilik/Operator (17 halaman)
Halaman CetakBEFORE OPERATING THE MACHINE:
Read the manual carefully and completely before attempting to operate the unit. This manual has important information
for the use and safe operation of the machine. Keep this manual handy at all times. This machine will ensure years of
satisfactory service if operated and maintained according to recommendations in this manual. If additional information is
needed, please contact your local distributor or contact EDIC:
EDIC Technical department: 800-338-3342 xt 109
EDIC EMAIL:
WARNING
•
The machine was designed for use on hard surfaces, carpet, floor and upholstery extraction applications as per
instructions and recommendations written in this manual. Any deviation from its proper use or purpose and
the consequential damage that may occur is the sole responsibility of the end user.
•
Disconnect the power cord from the outlet before servicing. Do not leave machine connected to an electrical
outlet when unattended.
•
Do not immerse or use this machine in standing water. Such use may cause electric shock.
•
When using an extension cord, use only a 3-prong conductor grounding cord-12 gauge wire or heavier.
•
To avoid electric shock, do not expose the unit to rain or snow. Store it indoors in a heated location only.
•
Do not use the machine for dry vacuuming.
•
Never use without pre-filter bag.
•
Use defoamer at all times to prevent damage to the vacuum motor.
•
Do not use water in excess of 130°F (54°C) in the solution tank
•
To prevent seal damage and chemical build-up to the pump system, run clean water through the solution lines
after each day's use.
•
Use only commercially available carpet cleaning solutions and defoamer intended for use with machines of
this type. Do not use dyes, bleaches, ammonia, or other additives. The use of powdered cleaning solution if
not diluted properly may result in damage to the pump. POWDERED CHEMICALS ARE NOT
RECOMMENDED. If powdered chemicals are used, premix in a separate container before placing in the
solution tank.
•
Always read and understand your chemical's MSDS (Material Safety Data Sheet) before use.
•
This equipment is not designed to handle or use combustible/volatile substances such as gasoline or kerosene,
in, on, or near the machine. The use of such materials will cause extreme hazardous condition.
•
Do not expose machine to freezing temperatures.
•
All repairs must be done by an authorized EDIC repair station.
•
Do not use replacement parts other than original EDIC parts.
•
Do not allow your spray stream to remain in one fixed location as surface damage may occur.
•
Check that all spray nozzles are securely fastened. Loose nozzles could be ejected from equipment at high
speeds.
•
Prevent burns by wearing gloves or using a barrier to remove hot quick disconnects.
•
This is not a toy. Keep away from children.
•
Do not pull by the power or use power cord as a handle. Always unplug by grabbing the plug and pulling, do
not unplug by pulling the power cord.
•
Inspect cord for damage. Do not use damaged cords. Connect only to properly grounded outlets.
•
Keep hair, fingers, loose clothing, and body parts away from moving parts and openings.
•
Turn off all controls before disconnecting machine
•
Use caution with ejected liquid or chemicals. High pressures and temperatures could be hazardous to nearby
people or surroundings.