EDIC-mini EM Tiny Plus Series Panduan Pengoperasian - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Perekam Suara EDIC-mini EM Tiny Plus Series. EDIC-mini EM Tiny Plus Series 17 halaman.
Halaman Cetak
6. Installing and replacing batteries
Note! Only for recorders with replaceable battery (B-type models)
Before starting, install the supplied battery. The LED flashes 3 times and it will be on
for about 40 sec. Now the recorder is ready to start operating. When installing, always
observe polarity (marking on the recorder's case corresponds to the one on the battery).
Incorrect installation of battery may lead to malfunction, which is not covered
by the warranty repair.
7. Supplying power for E71,E72,E84
Switch the recorder to OFF position and then connect DC power supply (3.6-6V) to
pins 1 (minus, gold colored wire) and 2 (plus, red colored wire) of the cable coming
from the Recorder. If the voltage source is represented by a Li-Pol battery, the
connected pins 2 and 3 (green colored wire) of the cable can provide battery
charge with the current of 100mA (provided the recorder is connected to the adapter,
and the adapter is connected to the USB).
8. Start and Stop Recording
To start recording, set the Switch to «On». The LED flashes five times, and the recorder
starts recording. During recording, the LED is flashing, the number of flashes
indicating:
Number of flashes
1
Operation the Recorder
Battery charge level
(1st series)
80 - 100%
Free memory capacity
(2nd series)
75 - 100%