EDIC-mini CARD24S Panduan Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Peralatan Perekaman EDIC-mini CARD24S. EDIC-mini CARD24S 8 halaman.

If a memory card error occurred during Recorder's operation, the Recorder's LED will start flashing frequently.

In this case remove memory card and check its functionality on any other device.

Battery Charging

Charge this model via memory card connector using USB cable from the delivery set.

Connect the cable to any power supply unit with a current of at least 500 mA, and the other end (resembling

memory card) must be installed into the Recorder's memory card connector.

The blue LED will be on to indicate battery charging process. After that the green LED will be on to indicate

charging has been completed. To disconnect the cable, gently press it and remove it from the Recorder.

Important! Do not pull the charging cable out of the slot, this may lead to failure of the card reader slot.

Note: if you connect the charging cable in reverse order, i.e. first insert the charging cable into the memory

card connector, and then turn on the charger, in this case when the cable is connected to the Recorder, the

red indicator will start flashing and it will be on until the charger is turned on.

Indication of errors in the operation of the Recorder and troubleshooting:

• Sequential three-fold flashing of the red and green indicators - firmware file is damaged, software needs to

be updated.

• Frequent continuous flashing of the red indicator - the memory card can not be initialized or unusable for

recording. Remove the card, wait about 2 seconds and reinstall it.

see section "Inserting / Removing a Memory Card" section.