AIMS Power PWRINV250024W Buku Petunjuk - Halaman 6
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Inverter AIMS Power PWRINV250024W. AIMS Power PWRINV250024W 10 halaman. Dc to ac power inverter
inverter in a moving vehicle, we recommend that you secure the inverter to prevent it from
shifting around while the vehicle is moving.
•
Do not operate this inverter in or around water. Water can damage the inverter, and water
damage is not covered under warranty. Also, do not operate the inverter with wet hands. The
AC voltage of the unit makes it an electrical shock hazard if operated with wet hands.
•
Allow at least 12 inches of clearance around the Inverter for air flow. Ensure the ventilation
openings on the rear and bottom of the unit are not obstructed.
•
Do not connect the inverter directly to another AC power source. Damage may result, and
such damage will void the inverter warranty.
•
Know the wattage requirements of your appliance. Use only those appliances which are
limited by the capacity of this unit.
•
Use common sense. This device produces power just like your wall outlets at home and
should be treated seriously. Keep it away from children.
•
Reversed polarity of AC power outlet LINE /NEUTRAL will void the warranty.
•
If there is anything wrong with the inverter, disconnect all of the power and contact technical
support.
TROUBLESHOOTING
If the Inverter does not appear to be functioning properly, check the following possible causes:
•
Poor contact: Clean contact parts thoroughly.
•
If the low battery alarm sounds, this means the input voltage is too low and battery
needs to be recharged.
•
If you are getting a low output voltage, try reducing the load to minimize watts. You may have
overloaded the inverter. Reduce your load. Also, keep input voltage above 10.5 volts to
maintain a constant flow of power.
•
If you are not getting any power output, turn the power switch Off and On again, until the
green power light comes on. Your devices may draw too much power to operate them. The
inverter may be in thermal shutdown. Let it cool down and make sure there is adequate
ventilation around the unit.
•
If the green light turns red one of the following has happened:
A. input voltage is too low
B. input voltage is too high
C. short circuit
D. inverter is close to overload
•
Battery voltage is too low: Start the engine to recharge the battery. Replace or recharge
battery if needed.
•
Shuts down on overload: Reduce the wattage of your load.