Akku Power 7S3P Instruksi Keselamatan - Halaman 5
Jelajahi secara online atau unduh pdf Instruksi Keselamatan untuk Aksesori Kamera Akku Power 7S3P. Akku Power 7S3P 12 halaman. Li-ion dt2 battery, 25.2v / 9.0/5.0ah / 226.8/126wh, idex fire & safety
Juga untuk Akku Power 7S3P: Manual (14 halaman)
Halaman CetakAll possible LED combinations are listed in table 2 to table 7
LED
LED
combination
combination number
1
2
3
4
5
Table 2: State of charge (SOC) indicator during charging
When the battery is placed on the tool the SOC will be displayed once,
for approx. 60 sec.
During charging and discharging on the tool the SOC is permanently
displayed. Disconnected from the tool and charger the state of charge
(SOC) is displayed for 25 seconds after pushing the query button. The
SOC lights turn automatically off after the indicated time or by pushing
the query button again.
LED
LED
combination
combination number
6
7
8
9
10
Table 3: State of charge (SOC) indicator on tool or stand alone
Description
Capacity = 100%
Capacity >=75%
Capacity >=50%
Capacity >=25%
Capacity < 25%
Description
Capacity >= 75%
Capacity >= 50%
Capacity >= 25%
Capacity < 25%
Undervoltage
(fast blinking)
Charge Cycles
The number of charging cycles is displayed when the button is pressed and
held for at least 5 seconds.To do this, first deactivate the SoC display and the
white LED on the back. Otherwise, the charging cycle query will not start.If you
have activated the white LED, the charging cycles will not be displayed. You
must first turn off the white LED.
Cycle counts
LED
LED
combination
comb.no.
11
12
13
14
Table 4: Cycle counter indication
Separator code
LED
LED
combination
comb.no.
15
Table 5: Error indicator
The separator codes light up once after the cycle counts.
State of health
If the usable capacity of the battery is smaller 60% of the installed capacity
(Ah), the SOH code will be displayed every time the battery comes out of the
sleep mode. Once the SOH code is shown on the display the user should
consider buying a new battery.
LED
LED
combination
comb.no.
16
Table 6: State of Health
Description
Cycles = Cycles + number of blinks
Cycles = Cycles + number of blinks x 10
Cycles = Cycles + number of blinks x 100
Cycles = Cycles + number of blinks x 1000
Description
Separator between cycle count and fault
memory indicator
Description
State of Health SOH < 60% all 4 LEDs
blinking for 10 sec
GB
5
5