dji Matrice M210 RTK Panduan Memulai Cepat - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Drone dji Matrice M210 RTK. dji Matrice M210 RTK 18 halaman. Matrice 200 series
Juga untuk dji Matrice M210 RTK: Panduan Memulai Cepat (15 halaman)

Halaman Cetak
Mounting the Gimbal and Camera
1 1
Press the Gimbal
Detachment button
to remove the cover.
Make sure to press down the gimbal detachment button when rotating the gimbal lock to remove the gimbal and camera. The gimbal lock should be fully rotated
when removing the gimbal for the next installation.
Mounting the Intelligent Flight Batteries
Insert a pair of batteries.
Press once to check the battery level.
Press again and hold until the batteries turn on or off.
Only use battery slot B when only using one battery to supply power.
Make sure to press the Battery Removal button when removing the battery.
Mounting the D-RTK Ground System
For the M200 series, only mount the D-RTK Ground System to
the M210 RTK.
1. Rotate the screws to secure the antenna bracket, and install
the battery.
2. Rotate the clamp to secure the battery, and install the
Datalink Pro antenna.
3. Install the D-RTK Ground System onto an appropriate tripod.
This manual uses the Datalink Pro 900 as an example. Please refer to the
D-RTK and Datalink Pro user guides for more details.
Mounting the GPS Module (Optional)
A GPS module is required when a single upward
gimbal is in use.
Remove the D-RTK
antenna on the left
side (facing the aircraft
nose) and mount the
GPS module.
Make sure you secure the GPS module and upward gimbal's cables with the cable clamps for safety.
The GPS module should be installed on the left side when facing the aircraft nose. Note that the whole aircraft will not retain its IP43 rating if the GPS module is installed.
8
2
Align the white and
red dots and insert
the gimbal.
Connect the GPS module
to the Extension Port, and
ensure that the side with
the logo faces upward.
3
Rotate the gimbal
lock to the locked
position.
A
B
1
3
2
High
Low
4
5
1/4"or3/8"
Mount the
upward gimbal,
and connect it to
the DGC2.0 port.