dji Zenmuse H3-3D Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Drone dji Zenmuse H3-3D. dji Zenmuse H3-3D 18 halaman.

Halaman Cetak

ZENMUSE H3-3D User Manual

Refer to GCU and Flight Control System Connection for more information about the connection.

For details on the flight control system connections, refer to the corresponding flight control

system user manuals.

3. Connect the GCU to the flight control system. Then connect the 8-Pin cable of the gimbal to

the G8 port on the GCU.

Flight Controller

GCU and flight control

System connection

GCU Power Cable

Connection

Gimbal Tilt Control Channel

4. Connection is complete. Power on the aircraft to launch.

5. To fully utilize the gimbal, you will also need to configure its tilt function. Each flight control

system assigns a specified channel (X3 channel for WKM, X1 for NAZA-M, and H3-3D for A2)

to for tilt control. To activate the tilt function, set up the channel in the PC Assistant and ensure

the connection between the receiver and the main controller is correct. Refer to the gimbal PC

Assistant for details.

GCU and Flight Control System Connection

The PMU and GCU can both connect to the same LiPo 3S-6S battery.

The GCU can be connected to any CAN ports on the PMU or to the CAN port on the GPS.

(Any spare CAN port on the WKM system.)

Control the tilt motion via the X3 channel. Properly configure the corresponding channel on

your remote controller.

Connect to the

Connect the GCU to a

CAN 2 port on

spare CAN-Bus port on

the A2.

the WKM system.

Connect the power cable to a connecter or solder the power cable to the

central board as needed.

H3-3D

Battery

positive pole(+)

(3S~6S)

negative pole(-)

V-SEN

3V 5V

P M U

WKM

NAZA-M V2

Connect the GCU to the CAN-

Bus port on the PMU V2

module.

(2V 6V)

WKM Connection Diagram

NAZA-M