dji Agras T25 Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Quadcopters dji Agras T25. dji Agras T25 7 halaman. Atomized sprinkler package
Juga untuk dji Agras T25: Informasi Produk (18 halaman)

Halaman Cetak
dji Agras T25 Panduan Memulai Cepat
② Press the Spray button to start or stop spraying manually in order to exhaust air.
B. Calibrating the flow meter
① In the app, go to Operation View, tap
section.
② Tap Start Calibration and calibration will start automatically. The result of the calibration will be displayed in
the app when completed.
● After calibrating successfully, users can proceed with the operation.
● If calibration fails, tap the reminder to view and resolve the problem. Afterwards, recalibrate and wait for
successful calibration.
Flight
In order for the aircraft to automatically take off and perform an operation, it is recommended to creat a plan for a
field and select an operation before takeoff. Refer to the Starting Operations section for more information. For other
scenarios, take off and land manually as follows.
Takeoff
Perform a Combination Stick Command (CSC) and push the throttle stick up to take off.
O
R
Landing
Push the throttle stick down until the aircraft lands. There are two methods to stop the motors after landing.
Method 1: When the aircraft has landed, push and hold the throttle stick down. The motors will stop after three
seconds.
Method 2: When the aircraft has landed, push the throttle stick down, and perform the same CSC that was used to
start the motors. Release both sticks once the motors have stopped.
 Spinning propellers can be dangerous. Stay away from spinning propellers and motors. DO NOT start
the motors in confined spaced or where there are people nearby.
 Maintain control of the remote controller as long as the motors are running.
 DO NOT stop the motors mid-flight. Otherwise, the aircraft will be crashed. Stop the motors only in an
emergency situation to reduce the risk of damage or injury.
 It is recommended to use Method 1 to stop the motors. When using the Method 2 to stop the motors, the
aircraft may roll over if it is not completely grounded. Use Method 2 with caution.
>
, then tap Calibration on the right of the flow meter calibration
Throttle Stick (left stick in Mode 2)