dji Matrice 210 V2 Panduan Pengguna - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Kamera dji Matrice 210 V2. dji Matrice 210 V2 6 halaman. Manifold 2 mounting bracket
Juga untuk dji Matrice 210 V2: Panduan Pengguna (12 halaman)
Halaman Cetak
Disclaimer and Warning
Congratulations on purchasing your new DJI
affects your safety and your legal rights and responsibilities. Read this entire document
carefully to ensure proper configuration before use. Failure to read and follow instructions
and warnings in this document may result in serious injury to yourself or others, damage to
your DJI product, or damage to other objects in the vicinity. This document and all other
collateral documents are subject to change at the sole discretion of DJI.
By using this product, you hereby signify that you have read this disclaimer and warning
carefully and that you understand and agree to abide by the terms and conditions herein.
You agree that you are solely responsible for your own conduct while using this product,
and for any consequences thereof. You agree to use this product only for purposes that are
proper and in accordance with all applicable laws, rules, and regulations, and all terms,
precautions, practices, policies and guidelines DJI has made and may make available.
DJI accepts no liability for damage, injury or any legal responsibility incurred directly or
indirectly from the use of this product. The user shall observe safe and lawful practices
including, but not limited to, those set forth in this document.
Notwithstanding above, your statutory rights under applicable national legislation are not
affected by this disclaimer.
DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as "DJI") and its affiliated
companies. Names of products, brands, etc., appearing in this document are trademarks
or registered trademarks of their respective owner companies. This product and document
are copyrighted by DJI with all rights reserved. No part of this product or document shall be
reproduced in any form without prior written consent of or authorization from DJI.
Introduction
The Single Upward Gimbal Connector is used to mount a compatible camera to the top of
the MATRICE
TM
210 V2 / Matrice 210 RTK V2 aircraft. Its design gives it an IP43 Ingress
Protection (only when equipped with a waterproof camera), in accordance with the global
IEC 60529 standard. The ZENMUSE
products are supported.
In the Box
Single Upward Gimbal Connector × 1
M2.5×14.2 Screw × 8
H2.0 L-type Wrench × 1
Installation
1. Place the single upward gimbal connector on the top of the aircraft, make sure that the
four screw holes align with the upward gimbal mounting position on the aircraft.
2. Use the wrench to tighten the screws to ensure that the single upward gimbal connector
is securely mounted.
3. Connect the single upward gimbal connector to the aircraft's DGC2.0 gimbal connector I.
product. The information in this document
TM
TM
X4S, X5S, X7, XT, XT2, Z30 and DJI Payload SDK