dji OSMO MOBILE 6 Panduan Keselamatan - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Keselamatan untuk Aksesori Kamera dji OSMO MOBILE 6. dji OSMO MOBILE 6 15 halaman.
Juga untuk dji OSMO MOBILE 6: Panduan Pengguna (19 halaman)

Halaman Cetak
dji OSMO MOBILE 6 Panduan Keselamatan

Compliance Information

FCC Compliance Notice
Supplier's Declaration of Conformity
Product name: Osmo Mobile 6
Model Number: OE200
Responsible Party: DJI Technology, Inc.
Responsible Party Address: 201 S. Victory Blvd., Burbank, CA 91502
Website: www.dji.com
We, DJI Technology, Inc., being the responsible party, declares that the above mentioned model was tested to
demonstrate complying with all applicable FCC rules and regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End
user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
ISED Compliance Notice
CAN ICES-003 (B) / NMB-003(B)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1)
This device may not cause interference. (2) This device must accept any interference, including interference that
may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) L'appareil ne doit pas produire de brouillage;
(2)L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This equipment complies with RSS-102 radiation exposure limits set forth for an uncontrolled environment.
End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device
is designed to meet the requirements for exposure to radio waves established by the CNR-102.
Cet équipement est conforme aux limites d'exposition aux rayonnements RSS-102 établies pour un
environnement non contrôlé. L'utilisateur final doit suivre les instructions spécifiques pour satisfaire les
normes. Cet émetteur ne doit pas être co-implanté ou fonctionner en conjonction avec toute autre antenne ou
transmetteur. Le dispositif portatif est conçu pour répondre aux exigences d'exposition aux ondes radio établie
par le développement énergétique DURABLE.
部件名称
铅
(Pb)
线路板
×
外壳
×
液晶屏
×
（如有）
金属部件
×
（铜合金）
内部线材
×
其他配件
×
本表格依据 SJ/T 11364 的规定编制。
○ ： 表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572 规定的限量要求以下。
× ： 表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572 规定的限量要求。
( 产品符合欧盟 ROHS 指令环保要求 )
KCC Compliance Notice
"해당무선설비는 운용 중 전파혼신 가능성이 있으므로 인명안전과 관련된 서비스는 할 수 없습니다 ."
"해당 무선설비는 운용 중 전파혼신 가능성이 있음"
NCC Compliance Notice
取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特
性及功能。低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至
無干擾時方得繼續使用。前述合法通信，指依電信管理法規定作業之無線電通信。低功率射頻器材須忍受合法通信或
工業、科學及醫療用電波輻射性電機設備之干擾。
8
汞
镉
(Hg)
(Cd)
○
○
○
○
○
○
○
○
○
○
○
○
有害物质
六价铬
多溴联苯
+6
(Cr
)
(PBB)
○
○
○
○
○
○
○
○
○
○
○
○
多溴二苯醚
(PBDE)
○
○
○
○
○
○