dji Zenmuse H2-2D Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Kamera dji Zenmuse H2-2D. dji Zenmuse H2-2D 16 halaman.
Halaman Cetak
Assembly
Gimbal Description
Notes:
(1)
Mack sure nothing blocks the servo driver module rotation, to avoid Servo Driver Module damage.
(2)
Clear obstacle at once if the rotating gimbal is blocked.
STEP1. Mount the Gimbal to the Aircraft or Landing Gear
The following procedure applies to DJI F450, DJI other type of aircraft or to your own aircraft. For DJI F450,
there are diagrams for your reference.
1.
Attach the Vibration Absorber to the Top Board of Damper Unit shown in Fig.1.
2.
Mount the Top Board of Damper Unit to the Bottom Board of aircraft; fix the M3x8screws, M3 spacers
and M3 nuts shown in Fig.2.
3.
Plug one port of the 8-Pin cable into the 8-Pin port on the gimbal shown in Fig.3.
4.
Tighten the M2.5x5 screws to fix the gimbal to the Bottom Board of Damper Unit shown in Fig.4.
5.
Attach the Vibration Absorber to the Bottom Board of Damper Unit shown in Fig.5.
6.
Make sure the damping unit is horizontally mounted and both damping boards are paralleled to the
bottom of the aircraft, further to make sure the gimbal is precisely and firmly assembled.
Notes:
(1)
This product does not include any extra aircraft, landing gear or camera, please prepare them by yourself.
©2013 DJI Innovations. All Rights Reserved.
Top oard of the Damping Unit
B
Vibration Absorber
Bottom oard of the Damping Unit
B
Port of 8-Pin Cable
(
)
To GCU G8
Camera Fixed Mounting
Camera Mounting Base
Servo Driver Module(Roll)
Camera Interface
Servo Driver Module(Tilt)
5