dji Zenmuse H3-2D Panduan Pengguna - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Kamera dji Zenmuse H3-2D. dji Zenmuse H3-2D 16 halaman.
Halaman Cetak
Appendix
.
Keep the power-on gimbal system still and horizontally during test. If you have to hold and move the
aircraft with power-on gimbal, the inclination angle of the aircraft should not exceed 35°.
Please do not land the aircraft with power-on gimbal on uneven ground (such as grass lawn or rocky
roads), in which environment there may have external forces act on the gimbal or the gimbal will get
shocked, then the gimbal will enter into Hibernation Mode.
Hibernation Mode for gimbal protection. In the condition that the camera is not mounted on the gimbal
the gimbal will enter into Hibernation Mode, in which the gimbal is out of control from Transmitter. You
must mount the camera correctly and power cycle the system to activate the gimbal.
Hibernation Mode for gimbal protection. When certain external forces act on the gimbal, it will enter
Hibernation Mode too. You must take notes to avoid too large forces affecting the normal working status
of gimbal and power cycle the system to activate the gimbal.
It's better to use separate battery pack to test the gimbal at the beginning to ensure functionality before
making steps to power on of flight controller, gimbal, OSD, FPV gears etc.
Appendix
Trouble Shooting
NO.
What
Gimbal
keeps
1
after initialization
The gimbal is abnormal
2
after initializing
Can't distinguish gimbal
3
pointing when using
©2013 DJI Innovations. All Rights Reserved.
(1) TX trims are too much
(2)GCU and autopilot system is
drifting
disconnected
(3)Gimbal mounting direction is
disaccording to aircraft nose
Abnormal
manufacture
BVR flight
Why
(1) Adjust the TX trims
(2)Connect
system
(3)Ensure Gimbal mounting direction
is the same with aircraft nose
calibration
after
Please contact local dealer or
Innovations
Try
transmission module.
How to
GCU
and
autopilot
customer service
to
use
a
wireless
DJI
video
15