dji DT7 Panduan Pengguna - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kontrol Jarak Jauh dji DT7. dji DT7 7 halaman. 2.4g rc system
Juga untuk dji DT7: Panduan Pengguna (5 halaman)
Halaman Cetak
3. Run the RC SYSTEM Assistant software. Wait for the remote controller to connect to the Assistant software.
When the connection indicator is solid green
Firmware Upgrade
1. On the [Info] page, click
2. Power cycle the remote controller after finishing the upgrade. Check the firmware version on the [Info] page, if
Assistant software shows the latest version, upgrade was successful.
Stick Mode Configuration
1. Select your custom control mode in the Stick Mode bar on the [Main] page.
2. Power cycle the remote controller, push both sticks and observe whether the cursors in the respective channels
are moving. This will confirm stick mode configuration.
Sticks Calibration
1. On the [Main] page, click the "Calibration" button to calibrate the sticks following prompts.
2. Calibrate the remote controller after every firmware upgrade or configuration, and calibrate on a regular basis.
DT7&DR16 Specifications
DJI DESSET 2.4G SYSTEM
Operating Frequency
Communication Distance open area
Remote Controller
General
Working Current
Battery Required
DJI Receiver 16
General
Receiving Sensitivity 1%PER
Working Current
Power Supply
Size
Weight
©2013 DJI Innovations. All Rights Reserved.
- 4 -
and the communication indicator blinks blue
to download and install the upgrade following prompts.
Latest version
DT7
2.4GHz ISM
1000m
2-stick, 7-channel
100mA@6V
4 AA Batteries
2.4GHz D-BUS System
-97dBm
145mA@5V
4~8.4V
41mmX29mmX5mm
10g
, it has connected.