djm direct DJMSS406 Panduan Pengoperasian - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Melihat djm direct DJMSS406. djm direct DJMSS406 19 halaman. Scroll saw
Halaman Cetak
7. Introduction
Your new Scroll saw will more than satisfy your
expectations. It has been manufactured under
stringent quality standards to meet superior
performance criteria. You will find it easy and safe to
operate, and with proper care, it will give you many
years of dependable service.
Carefully read through this entire
operator's manual before using your
new Scroll saw. Take special care to
heed the cautions and warnings.
High performance and powerful variable speed
scroll saw. Suitable for precise or intricate cuts in
wood, plastic, metal, plexiglass and plaster.
8. Application Conditions
This scroll saw is designed for operating under
ambient temperatures between +5°C and 40°C
and for installation at altitudes no more than
1000m above M.S.L. The surrounding humidity
should less than 50% at 40°C. It
* S2, Short-time duty. After continuous operation
of 10 minutes the drill stops until the device tem-
perature deviates by less than 2 K (2°C) from the
room temperature.
Sound pressure
level (LPA)
Sound power level
(LwA)
* The noise was measured according to clause
13.2 of EN 61029-1:2009+A11
78.1 db(A)* k=3 db(A)
88.6 db(A)* k=3 db(A)
9. Machine Use and Care
-Do not use low-output electric tools for heavy work.
Do not use the electric tool for purposes for which it
is not intended. For example, do not use hand-held
circular saws for the cutting of branches or logs. Do
not use the electric tool to cut firewood.
-When the saw blade is blocked due to abnormal
feed force during cutting, turn the machine off and
disconnect it from power supply. Remove the work
piece and ensure that the saw blade runs free. Turn
the machine on and start new cutting operation with
reduced feed force.
-Do not remove any cutting residues or other parts of
workpieces from the cutting zone while the machine is
running and the saw unit is not at rest.
Never remove loose splinters, chips or jammed pieces
of wood while the saw blade is running.Switch off the
machine to troubleshoot or remove jammed pieces of
wood.
-Refitting, including adjusting and measuring works,
and cleaning must be carried out only when the motor
is switched off. - Disconnect the main power plug -
Before switching on again, ensure that keys and
adjustment tools have been removed.
-Take care of your tools. Keep cutting tools sharp and
clean in order to be able to work better and more
safely. Follow the instructions for lubrication and for
tool replacement.
-Check the connection cable of the electric tool
regularly and have it replaced by a recognized
specialist when damaged. Check extension cables
regularly and replace them when damaged. Keep the
handle dry, clean and free of oil and grease.
-Check the electric tool for potential damage.
Protective devices and other parts must be carefully
inspected to ensure that they are faultfree and
function as intended prior to continued use of
the electric tool. Check wether the moving parts
function faultlessly and do not jam or whether
parts are damaged. alll parts must be correctly
mounted and all conditions must be fulfilled to
ensure faultfreeoperation of the electric tool. The
moving protective hood may not be fixed in the open
position. Damaged protective devices and parts must
be properly repaired or replaced by a recognised
workshop, insofar as nothing different is specified
in the operating manual. Damaged switches must
be replaced at a customer service workshop. Do not
use any faulty or damaged connection cables. Do not
use any electric tool on which the switch can not be
switched on and off.
6