djpower djV PRO STAGE EFFECTS DC-1 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan DJ djpower djV PRO STAGE EFFECTS DC-1. djpower djV PRO STAGE EFFECTS DC-1 11 halaman. C02 confetti blaster

Halaman Cetak
4
SETUP
4.1
AC Power
The machine has a fixed voltage power supply and can work with an input voltage of AC 220 V-240 V, 50/60 Hz, depending on the
specific model.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label
affixed to the product's back panel, or refer to the product's specifications chart. The listed current rating indicates the product's
average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make sure the product has an appropriate
electrical ground to avoid the risk of electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel
serves only as a 0 to 100% switch.
4.2

Power Plug

The machine comes with a power input cord terminated with a Lockable Powerkon connector on one end and an EU plug on the
other end (EU & China market). If the power input cord that came with your product has no plug, or if you need the change the
plug, use the table below to wire the new plug:
Connection
AC Live
AC Neutral
AC Ground
4.3

Fuse Replacement

•
Disconnect the product from power
•
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
•
Pry the safety cap out of the housing
•
Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact same type and rating.
•
Re-insert the fuse holder and reconnect power.
Disconnect the product from power before replacing the fuse.
4.4
REPLACE A CO2 CYLINDER
•
Close the connected CO2 cylinder.
•
After close CO2 cylinder, power on and empty the CO2 in the hose.
•
Disconnect power.
•
Disconnect the CO2 hose from the CO2 bottle-to-hose connector on the CO2 cylinder.
•
Remove the CO2 bottle-to-hose connector from the cylinder.
•
Connect a CO2 bottle-to-hose connector to a new CO2 cylinder.
•
Connect the CO2 hose to the CO2 bottle- to-hose connector on the new CO2 cylinder.
•
Open the CO2 cylinder.
•
In case of multiple machines, connected in series: Repeat step as recommended for each machine.
Wire (U.S.)
Black
White
Green/Yellow
5
Wire (Europe)
Brown
Blue
Green/Yellow