Custom Dynamics CD-FORK-BCM-SB Petunjuk Instalasi - Halaman 5
Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Aksesori Sepeda Motor Custom Dynamics CD-FORK-BCM-SB. Custom Dynamics CD-FORK-BCM-SB 5 halaman. Dynamic led fork reflectors
Halaman Cetak
7. Locate and remove the lower T-25 screw on each
side of the inner fairing. Refer to Photo 15.
15
8. Remove the outer fairing and set to side.
9. Using one of the BCM Adapter harnesses, plug the
black male connector of the pass-through into the
female connector of the turn signal wiring harness.
10. Leave the female 4 pin JAE connector of the pass-
through harness disconnected until the fairing is
reinstalled. Repeat for the other side.
11. On the left side BCM Adapter Harness, plug the 2
pin female connector into the male 2 pin connector
of the right side BCM Adapter Harness.
16
12. Locate the 2 pin fairing connector in the upper left
of the fairing. See Photo 16.
Questions? Call us at: 1 (800) 382-1388
Installation Instructions - Page 5
M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST
3. Remove the connector plug from the 2 pin
fairing connector on the motorcycle by push-
ing the center tab in and pulling the plug out.
Save the plug for reinstallation later. Refer to
Photo 7.
13. Plug the BCM Adapter Harnesses into the
fairing 2 pin fairing connector, ensure that it
snaps in. Make sure to reinstall the plug re-
moved in the previous step into the right side
BCM Adapter Harness pass-through connect-
or.
14. Using the provided wire ties, secure the BCM
Adapter Harnesses to prevent the wires from
being damaged during fairing installation.
15. Remove the OEM fork reflector from the low-
er fork leg. Clean the reflector area removing
any debris or tape from the OEM Reflector.
16. Wipe the reflector area down with the provid-
ed Isopropyl Alcohol Wipe and let dry.
17. Remove the protective red film from the back
of the LED Fork Reflectors. Align the LED
Fork Reflectors in the reflector area and press
into place. The LED Fork Reflector should be
mounted in the same location as the OEM
reflector with the wire exiting the top, rear
side of the light.
18. Route the wiring harness from each LED Fork
Reflectors to the associated side BCM Adapt-
er Harnesses in the fairing and connect to the
Female JAE Connector.
19. Using the provided wire ties, secure the LED
Fork Reflectors wiring harnesses to prevent
the wires from being damaged.
20. Reinstall the fairing and windshield in the re-
verse order that it was removed
21. Reconnect the negative battery cable to the
battery and reinstall the seat.
22. Perform a BCM sync by turning the ignition
on, turn the 4 way hazards on, turn the igni-
tion off. Allow the 4 way hazards to run for 3-4
minutes. Turn the ignition on. Turn the 4 way
hazards off. Turn the ignition off.
23. Test operation of all lighting in all modes be-
fore riding.
04/2020