Custom Dynamics Dynamic Strips CD-DS-ST-B Panduan Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Sepeda Motor Custom Dynamics Dynamic Strips CD-DS-ST-B. Custom Dynamics Dynamic Strips CD-DS-ST-B 7 halaman.

Halaman Cetak

Note that there is a gap between the front plate and the

fork. Using the side rail, turn it over so that the back side is

facing outward (the side you don't see when installed), then

insert it in behind the front cover at the drill site. This will

protect the fork from being punctured by the drill bit. Drill

the holes with the same 1/4" drill bit.

Pair the right side strip with the right side rail, insert the wire through the rail. Make sure that the rail is oriented with the curve facing

outward (as if mounted on the bike) toward the strip. Remove the red backing from the 3M tape, then align the screw holes by line

of sight. Once properly aligned, press into place. Repeat for the other side.

Questions? Call us at: 1 (800) 382-1388

Installation Instructions - Page 4

M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST

Now that the drilling is complete, we must make sure that

there are no sharp rough edges on all parts of the cover that

could cut the wires from the Dynamic Strips™. Using a

de-burring tool like the one pictured, or a small circular metal

file, ream the holes to remove any debris.

09-2017