Artison RCC600-CM Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Subwoofer Artison RCC600-CM. Artison RCC600-CM 19 halaman. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount

Halaman Cetak

subwoofer module and the back of the box. Be careful that no wires are in this

area when installing the module.

RCC600-IFPBB

1. Please refer to the Installation Guide included in the Artison In-Floor Pre-Build Box Carton for

installation instructions.

2. Using the speaker wire already run inside the Pre-Build Box manage both the positive and

negative conductors through the open tie-wraps on each side of the RCC600-SM.

3. Connect the bare speaker wire ends to the spring-loaded binding posts, manage the speaker

wire back, tighten the tie-wraps and trim the excess.

4. Install the RCC600-SM by lowering the module sideways, into the opening. Once the module

is in the cavity it will rotate into the cutout.

5. Tighten the six dog leg screws with a #2 Philips screwdriver, a tool with a 90 degree bend is

recommended.

6. The grille for the RCC600-SM is held in place by magnets. Simply position the grille on the

front of the module into the recessed area.

7. Using the supplied hardware install the 2 L-Shaped Brackets to the inside of the box opening

and level the brackets with the level of the finished floor.

8. Install the Grate to the L-Shaped Brackets using the supplied hardware.

INSTALLATION INTO AN INFINITE BAFFLE

1. Use the provided Cut-out Template to mark the desired wall location. Be sure that no piping,

wall studs, or electrical wires interfere with the placement of the RCC600-SM.

2. Once the hole is cut and the speaker wire is run, manage both the positive and negative

speaker wire conductors through the open tie-wraps on each side of the RCC600-SM.

3. Connect the bare speaker wire ends to the spring-loaded binding posts, manage the speaker

wire back, tighten the tie-wraps and trim the excess.

4. Install the RCC600-SM into the cut-out made in the wall.

5. Carefully tighten the six dog leg clamps on the RCC600-SM using a #2 Philips Head

Screwdriver.

6. The grille for the RCC600-SM is held in place by magnets. Simply position the grille on the

front of the module into the recessed area.

NOTE: While installing the subwoofer module ensure any excess wire is run properly

so it does not interfere with the driver's operation.