DK-TEC SAVCDH Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin Pemotong Rumput DK-TEC SAVCDH. DK-TEC SAVCDH 15 halaman. Flail mower
Halaman Cetak
•
Make sure the PTO is properly connected after each connection of the machine.
•
Uncouple the machine from the tractor only on a compact and flat surface to avoid sudden
movement of the machine
•
Use the machine with sufficient natural light or, alternatively, use the tractor's lighting system.
WARNING!
Make sure that the safety shields around the PTO are always complete and that they
are in good condition.
In the event of breakage or deterioration of the PTO shaft safety shields, immediate
replacement must be provided.
WARNING!
Never stand between the flail mower and the tractor!
DANGER!
Do not modify the safety shields on the machine as this may affect safety.
Use only original spare parts for your machine. DK-TEC considers itself free from any liability in the
event of:
•
Improper use of the flail mower by untrained people
•
Serious lack of the planned maintenance procedure
•
Unauthorized changes or interventions
•
Use of non-original spare parts
•
Total or partial non-compliance with the instructions
•
Failure to comply with the common safety standards within the work area
•
Outstanding events
Make sure that the hydraulic pipes are connected correctly by observing the
color codes, as it must be remembered that otherwise it may cause the
opposite movement than desired.
•
Check the wear condition of the hydraulic pipes. In case of
deterioration, they must be replaced. In any case, replace the
hydraulic pipes every 5 years.
•
When the machine is not connected to the power supply, the hydraulic
pipes must be connected to the special supports.
WARNING!
Make sure the flail mower is completely stationary before approaching it.
Long-term use of the machine can cause the engine and the belts on the
hydraulic system to become very hot. DO NOT touch these parts during or
immediately after operating the machine.
Any changes to the machine may cause problems. In that case, the user is
solely responsible for any accidents.
7