DK-TEC SP31205 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin Pemotong Rumput DK-TEC SP31205. DK-TEC SP31205 15 halaman. Atv mower

Halaman Cetak

Before starting

1. Before starting, check that the mower and the towing enhed are securely interconnected.

2. Always

approved safety equipment, eye and hearing protection, gloves and work

wear

boots when operating the machine.

3. Check that the engine is set to run at full throttle for the best cutting performance.

4. Carefully rise on the towing device and start work at a slow speed. Do not exceed the

maximum working speed of 8 kilometers per hour.

CAUTION

Maximum cutting speed is 8 kilometers per hour. Maximum towing speed is 15 kilometers per

hour (the engine of the machine must be turned off here)

Stop the mower

1. Stop the towing unit, turn off the engine, turn the fuel tap to

handbrake.

2. Turn off the engine of the machine by turning the key to the "OFF" position.

3. Turn the engine fuel tap to the "OFF" position.

4. Always

remember

Transportation of the mower

1. It must be ensured that the engine is turned off.

2. Raise the mower so that the blades are in

transporting the machine, remove

When

ensure that

cannot make contact with the spark plug by mistake.

6. Maintenance and storage

WARNING

Failure

to maintain and store the mower may result in warranty lapses.

General maintenance

•

Before performing maintenance,

•

After any maintenance, it must be ensured that all screens and safety equipment are back

in place before operating the mower.

•

Check all nuts and bolts daily for proper tightening.

•

Lubricate pulley bearings, (the knife spindles). They should not

pump for every 15-

•

For each season, all moving parts should be cleaned and lightly lubricated as needed.

•

Use a high-gloss machine paint to repair scratches or worn metal surfaces.

•

Never

pressure washers or water hoses to clean the engine while it is running or hot.

use

to remove the key to avoid unauthorized use.

engine of the machine must be turned off.

the

20 working hours.

the

highest position.

the

spark plug cap from

the

"OFF" position and pull the

spark plug and

the

over lubricated. Use 1