DK-TEC SPCPR150 Panduan Pengguna - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Chipper DK-TEC SPCPR150. DK-TEC SPCPR150 12 halaman. 15 hp wood chipper with electric start
Halaman CetakIntended use
•
The chipper is designed exclusively for fine cutting/chipping of all kinds of branches with one
diameter of up to a maximum of 8.5 cm.
Restriction
•
You must not use the chipper for fine cutting/chipping of metal, stone, plastic.
•
Check that the bolts on the blades and the counter knife are tight and that the distance
between the blade and the counter knife is 0.5 mm. Adjust if necessary and tighten the
bolts.
The description of the machine
•
The file chipper is a machine for finely cutting/chipping wood. The rotor has two blades
each with a width of 30 cm and is driven by a petrol engine. The transmission cuts through
two parallel drive belts. Chipped wood is discharged through the outlet pipe. Due to the
angle of the blade and the location of the counter knife, the branches are drawn into the
machine almost automatically. (See figure 2a, 2b, on page 2)
Starting the machine:
•
Start by pressing the ON button to (Figure 3)
•
Open the gas tap
•
Set the choke to ON
•
Turn on the gas by pushing the gas control
•
Turn the key to turn on the machine.
Spare parts
Always use original spare parts, otherwise the warranty will be void! You can easily find the spare
parts
that fits the machine, by scanning the scan code on
your machine's CE plate.
Download the app 'QR scanner' on
your smartphone in the Play Store or
App Store to be able to scan the scan
code.
1. General
01/2020
1