DK2 Power OPC566E Lembar Faq - Halaman 3

Jelajahi secara online atau unduh pdf Lembar Faq untuk Chipper DK2 Power OPC566E. DK2 Power OPC566E 13 halaman. Tips, tricks & frequent questions
Juga untuk DK2 Power OPC566E: Panduan Pengguna (17 halaman)

Halaman Cetak

THE BASICS

HOW DO I START THE OPC566E?

STARTING

Position your Wood Chipper on flat, dry ground.

Make sure the fuel shut-off valve is in the

Move the choke control lever to the

needed if the engine is cold).

Move the throttle control lever to the

Recoil Start: Turn the Ignition Switch to the

recoil starter handle and slowly pull until you feel resistance. Let the cord

retract a little bit then pull the cord rapidly to start the engine. One or two

pulls usually starts the engine.

Electric Start: Turn and hold the key in the start position until Engine starts

then let the Key return to run position.

Move the choke control lever (if used for cold engine) slowly back to the

"RUN"

position when the engine is running well.

If the Wood Chipper has not been running (cold engine), warm up the

engine by running the engine at half throttle for 3 to 4 minutes, then advance

the engine throttle control to the maximum speed.

BACK TO MAIN MENU

"ON"

position.

"CHOKE"

position (should only be

"FAST"

position.

"ON"

position. Grasp the