DK2 Power OPG777 Panduan Perakitan - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Penggiling DK2 Power OPG777. DK2 Power OPG777 16 halaman. Stump grinder

OPERATION – BEFORE TURNING KEY AND PULL STARTING ENGINE

CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED. THINK

SAFETY. CHIPS ARE FLYING PROJECTILES AND CAN CAUSE INJURY.

WEAR SAFETY GLASSES, HEARING PROTECTION, AND GLOVES

DO NOT WEAR LOOSE FITTING CLOTHES THAT COULD GET STUCK IN THE MACHINE

MOVING PARTS, ONLY CHIP WOOD, CHILDREN SHOULD NOT RUN THIS EQUIPMENT,

STAY ALERT OF YOUR SURROUNDING AND PERSONS THAT COULD APEAR IN THE

CHIP PATH WHILE YOU ARE WORKING.

UNIT IS A DIRECT DUAL BELT DRIVE. NO CLUTCH

TO SLIP OR BURN UP

BUT YOUR BELTS WILL NEED TIGHTENED AND CHECKED ON A REGULAR BASIS TO

MAINTAIN 100% CUTTING POWER.

•

Tip the Stump Grinder up with the cutters off the ground when pull starting.

APPROACH STUMP FROM THE TOP CUTTING STRAIGHT DOWN INTO THE STUMP

WITH THE 3.5 INCH WIDE CUTTING TEETH. RAISE UP OUT OF THE CUT, MOVE

OVER, PLUNGE AGAIN. REPEAT ACROSS ENTIRE STUMP. MOVE SIDE TO SIDE TO

FACE OFF THE STUMP. ADJUST YOUR BOW HANDLE FOR COMFORT.

SET ONE OF YOUR WHEEL BRAKES SO YOU CAN PIVOT THE MACHINE CUT.

TO MOVE THE MACHINE FORWARD WITH THE BRAKE ON, ALLOW THE ROTATING

TEETH AGAINST THE STUMP TO PULL THE UNIT FORWARD.

TIGHTEN ALL BOLTS AND TEETH BEFORE EACH USE. TEETH ARE NOT COVERED

UNDER WARRANTY. CLEAN ALL STONES AND ROCKS AWAYS FROM CUTTING STUMP

AREA, CHECK FOR METAL STAKES AND OR NAILS IN THE TREE STUMP BEFORE

CUTTING.

KOHLER ENGINES HAVE A LOW OIL SHUTOFF TO PROTECT THE ENGINE, TILTING THE

GRINDER HIGHER THAN 12 INCHES AT AN ANGLE CAN CAUSE THE OIL TO ROLL BACK

AND THE LOW OIL SENSOR WILL SHUT THE ENGINE OFF. CUT YOUR STUMP 9 TO 10

INCHES OFF THE GROUND SO YOU DON'T TRIP THE SENSOR ON THE ENGINE.

READ AND OBEY ALL WARNING LABELS ON THIS MACHINE.