Artistic License Ether-Lynx II Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Konverter Media Artistic License Ether-Lynx II. Artistic License Ether-Lynx II 13 halaman.

Halaman Cetak
DMX Output Settings
On the outputs, the DMX Settings tab enables
the following configuration options:
Set Net, Sub-Net & Universe values
y
Set profile (see 'Output Profiles' table
y
below)
Enable/disable RDM messages
y
Profile
RDM
Best
On
Compatibility
Off
Fix
Off
Custom
On/Off
Output Profiles
Delta: DMX Output packets are synchronised
*
with incoming Art-Net packets.
Continuous: DMX output packets are
**
continuously transmitted independently of the
Art-Net inputs.
IP Settings
The configuration menu for the IP settings
allows the user to set a custom IP address,
Subnet Mask and Gateway IP. There is
also an option to enable/disable DHCP for
automatic IP addressing (see 'IP Address
Configuration').
Ether-Lynx II User Guide
Transmit
Max
refresh
rate (fps)
Delta*
43.57
Delta
43.06
Continuous**
39.95
Delta/
16.76 -
Continuous
43.57
Module Info
The module info tab describes the jumper
functionality (see below), and also provides
some helpful information regarding the DMX
data transmission.
Jumpers:
Advanced Configuration
There are several advanced settings, beyond
the scope of normal operation, that can be
accessed by fitting the supplied jumpers over
the configuration pins. The pins can be found
on the bottom left of the PCB. To fit a jumper
follow the instructions below:
Disconnect the power from the unit
1.
Ensure you have adequate anti-static
2.
protection
Remove the top row of screws from the
3.
front panel
Remove the bottom row of screws from
4.
the rear panel
Carefully pull the two halves apart, about
5.
10cm
Jumper settings
Jumper
JP0
JP1
JP2
JP3
HTTP server disabled
(e.g. no web page
JP4
10.x.x.x IP addressing
enabled (ignored when
JP5
RDM disabled on all
JP6
Inverts the low byte of the
JP7
ROM
Switch to boot-loader
Boot
mode on power cycle
Option
For future use
For future use
For future use
functionality)
DHCP is active)
outputs
IP address
For future use
Page 8