Alula RE636 Wireless Outdoor Siren Strobe Connect+ Encrypted Panduan Memulai Cepat
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Sensor Keamanan Alula RE636 Wireless Outdoor Siren Strobe Connect+ Encrypted. Alula RE636 Wireless Outdoor Siren Strobe Connect+ Encrypted 2 halaman.
Halaman Cetak
The RE636 Wireless Outdoor Siren Strobe
warning device that produces high volume warning sounds and
visual strobing.
Features
• Multi-cadence siren
• 100 dBA minimum at 1m
• 2-5 year battery life (batteries included) or AC powered
(RE012-17 sold separately)
• 5-year warranty
Sounds
a high volume warning for burglary, smoke and carbon
monoxide alarm conditions. Volume is adjustable through the
Connect+ Installer application, or through the interactive service
provider's web portal.
Enroll
by placing the panel and siren into wireless enrollment
mode. The siren's PWR and RF LEDs will blink back and forth
when in enrollment mode. If the siren has never been enrolled,
enrollment mode will start automatically when opening the
cover. To overwrite a previously enrolled ID, power up the
device while holding the tamper. When the red RF LED
illuminates, release the tamper switch. After enrolling the siren,
take the panel out of wireless enrollment mode.
• Once the siren is properly enrolled, test functionality in a
desired location.
• The panel supports up to eight RE636 sirens at one time.
Replace batteries
cover to gain access to the 3 C-cell batteries.
• To remove inner cover, push down the two latches, then
pull out the clear inner cover.
Mounting
can be done by securing the siren to a surface with the
mounting screws (included) at the three slotted mounting holes.
Ensure arrows inside are pointed up.
Pro Tips
• Cover can hang from bottom of enclosure and inner cover can
clip into cover for convenience while work is being done inside
enclosure.
• To change the strobe lens, unscrew the cover screw until it
is past the lens, and then push on the corner of the lens to
loosen and remove. Select desired color.
• Power (PWR) LED will turn on when the siren is awake (every
18 seconds on battery and always when powered from wall).
• RF LED will blink when a packet is received.
• Enroll packets are automatically sent every 18 seconds when
in enroll mode. Pressing or releasing the tamper switch while
sensor is in enroll mode will send another enroll packet.
Use the panel installation guide to verify proper system setup.
by opening the cover and removing the inner
RE636 Wireless Outdoor Siren Strobe
Connect+
Encrypted
™
is an auditory
Mounting Holes
Inner cover
removal
latches
I